http://www.fixya.com/support/p96960-siemens_wfxd5200uc_front_load_washerSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comSat, 05 Dec 2009 18:08:19 GMT80http://www.fixya.com/support/t3129268-seimens_wfxd8400uc_01_washer_flasingSeimens WFXD8400UC/01 washer flasing ERROR (no code number)Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t1585529-pump_catch_machineDown on the bottom rightt hand corner of the machine is a cover remove the cover and there is a big black nut or cover if you remove this, there is a big white thing in there. What do these pieces do and is there supposed to be water in there? I took...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t672577-spinning_problem_in_machinehi, my machine is 9yrs old and since few days while spinning the water dosent drain out of the machine. Kindly advice on the same . Regards, ShrutiSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t1459853-checkhow do i check if the motor or brushes are working on my washing machineSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t654139-ripped_front_gasketis this hard to repair?Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t249739-helpI have 1 y/old washer, which leeks through the servise access port. I have called the 2 authorised from Simens busnesess which go to my area (91367), one gave my appoitment in first week in December, the other one, called Bud's Appliencess, directly...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t406614-door_switch_er_04Thank you very much for your help, I recently had the door gasket replaced by a service company, I complained after the repair was complete that the door was not in alignment and it had to be physically lifted up to close the door. . Is it possible...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t409582-washing_machineI have a Siemens Siwamat 276 washing machine. Its quite an old machine but has worked perfectly until recently, now it always heats the water to its maximum temperature, whatever temperature setting I choose with the dial. Is this a simple problem to...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t400641-water_not_drainThe washing machine fills with water, it spins , it does not drain the water after the cycle has ended. (error code E:04)Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t190737-hitachi_sf_h900tpx_washing_machine_notMy Hitachi SF-H900TPX Washing Machine has suddenly stopped washing / Spin Dry... It will fill the water to the correct level, but will not start to wash. If I then try to use the Spin selection, it will only drain the water out, but it wqill not...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t191557-g_e_washer_fills_slow_2nd_rinsemodel #wcse3100a1ww fills very slowly on 2nd rinse. i have cleaned all filters and replaced valve assembly. is the control asembly now the problem? how can i test it iSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t192117-maytag_top_load_washer_leakI have a maytag top load washer, about 15 years old. Once the washer fills, water still drips from the fill slot through all cycles, including the spin cycle. Even when the washer is turned off, it still drips.Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t192365-hotpoint_aquarius1100_electrical_probmy machine has just been moved from one house to another 4th floor flat today,and upon using it it seemed to work fine then it tripped the switch on that circuit ,it then seemed to work fine to just spin if i put it on that part of the cycle.now...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t194153-hoover_600m_washing_machine_cycle_issueOur washing machine won't progress through it's normal cycle. The dial no longer moves or clicks through to the next step in the washing cycle.Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t194539-kenmore_elite_he3_front_loading_washerI have had alot of trouble with this washing machine. I have had it for a 1&1/2 years. First the rubber around the door went out and now on of one of the plastic things connected to the steel drums broke off. It is suppose to be such a great washer...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t195457-washing_machineI recently moved into a fully furnished flat (renting). The place has a LG Direct Drive 7 3.5kg. I'm not sure how to use this machine, so I'm trying to find the manual for it....Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t193197-hotpoint_washerHi i have a 1987 hotpoint washing machine i have something stuck in the adjetator how do i get the adjetator off?Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t196497-hoover_elite_930_top_loader_washingAs the machine goes into the rinse cycle the cold water solenoid does not activate, it does activate in other cycles, such as filling up at the start.Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t196807-front_panel_removalOpen door button is tuck. We are trying to remove the front control panel for access so we can un stick the buttonSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t197645-used_kenmore_stackable_washer_dryer_p_nI bought a used kenmore stackable washer and dryer P/N 145781-000A. I wired an outlet for it in my condo. Since the plug has four prongs I installed a four prong outlet, but there are only three wires coming from the box: two 120v. hot wires and...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t196869-maytag_stops_any_cycle_after_warmHi, The washer stop in the middle of cycles after a while (usually in the second wash). Even if the cycle is changed it doesn't do anything. After couple of days and after the machine is disconnected you can use it again and it works fine but only...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t198529-replacing_fins_duet_whirlpool_washerI am trying to replace the plastic fins inside the drum of my whirlpool duet washer. I have the parts, and it is officially clled the drum baffle kit. I have a picture of how to install it, but how do I get to the drum? From the picture it looks...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t199347-miele_washing_machine_model_w713_front15 years old - no previous maintenance done Filters maintained clean. Problem: 1) machine leaks water underneath after completing wash & rinse cycle 2) always washes a very long time ( approx. 3 hours to complete) regardless of pressing short...Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t200789-problem_indesit_we16My indesit we16 keeps on saying door on the lcd screen about 3 mins after i try and start it. I changed the door interlock but this has not resolved the problem. Can anyone help?Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t199171-drain_pump_replacement_instructionI have a top mount Roper washer that's leaking from the Drain Pump (It's the only thing that's wet when i looked in the bottom). Is it possible to get a step by step instruction on replacing the pump?Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t204689-washing_machine_not_getting_cold_waterNot getting cold water. I think it might be the cold water solenoid. If this is the problem, how big of a job is it to replace the soleniid and where can get the parts and instructions. Estate TAWB600EQ Washing Machine.Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t205177-door_seal_hotpoint_9540How do I change the door seal (boot) on a Hotpoint 9540 washerSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t205803-washing_maching_not_taking_fabicHi, this machine is about 7 years old and work fine, except in the last couple of weeks it no longer takes in the fabic softner from the rinse draw. Apart from that everything is OK. Any idea on what's wrong?Sat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t206537-plastic_sleeveWater is pouring out of the plastic sleeve in the back of my washing machine. I am getting a ob code and a lf code as wellSat, 05 Dec 2009 18:08:19 GMThttp://www.fixya.com/support/t210225-washing_maching_belt_replacementWhite Westinghouse # wwx233rbs1 washer I can't seem to get it on its to tightSat, 05 Dec 2009 18:08:19 GMT