Saniflo SaniPlus-Round SaniPlus Macerator Toilet with Round Bowl - Answered Questions & Fixed issues

Ten years ,thats good but now needs to be replaced, newer models now available.

Ontact Saniflo they will send engineer out to rectify.

hi sounds to me that it is blocked these pumps are for waste only not paper etc

Force the brush tip back and forth, especially along the toilet jets (holes under rim), around the water line and on visible stains. Scrub until stains are gone, reapplying cleaner as necessary, then flush twice. To make your toilet bowl clean again, start with a dry bowl so water won't dilute the cleaner.

This is a bit of a puzzle, if theres water in the Suniplus then the float valve will operate and the water will pumped out as it does for the toilet and wash basin. I can only think that the bath discharge none return valve is stuck and needs removing and cleaning. Hope that solves the problem. Alllan

From dirt or age

Is your Saniplus humming or motor spinning slow or not at all?It is likely the internal motor control capacitor - It is the most common replacement part for these units and a fairly simple DIY although you will need rubber gloves and bleach. I have posted repair instructions for the Saniplus here:Saniplus Repair Instructions

7,950,000

does anybody know where you can purchase spares for the sanislim just im looking for a replacement motor?

cleaned it out and eventually must have disturbed some solid matter which was causing the problem

I think a small plastic item has dropped into my saniflo toilet it keeps maing a loud noise evey few minutes. hat should I do

6440

Already replied to this one.v

Here is a nice link for your saniflow maintenance.http://www.plumbteamltd.co.uk/sanifloguide.htmlThis will may help.

sounds like a stick float vave check this link on maintenance of your system.Here is a nice link for your saniflow maintenance.http://www.plumbteamltd.co.uk/sanifloguide.htmlThis will may help.

Here is a nice link for your saniflow maintenance.http://www.plumbteamltd.co.uk/sanifloguide.htmlThis will definately help.

Sounds like your external pipe may have a blockage tap the pipe to see if your hear a thud if it sounds clear check the toilet outflow pipe the same.. You may need to have your external pipes rodded.

Hat is what I am thinking also. Check it to see.

If anything goes wrong with the unit it usually happens in the pressure chamber, the motors are very durable, any part in there can be replaced. Im thinking the capacitor might have seized up and will probably need to be replaced.

Could be an obstruction in the blade, impeller or the discharge line. Also the starting capacitor may have gone bad and is not keeping up with the head pressure, it may need to be replaced. But i would suggest inspectin the unit first for any obstructions.