http://www.fixya.com/support/p941653-ryobi_30_cubic_centimeter_curved_shaft_gSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comTue, 22 Dec 2009 16:55:32 GMT80http://www.fixya.com/support/t3577522-ryobi_trimmer_not_spinningRyobi trimmer not spinning, the motor runs fine, I think the friction clutch is worn.Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3519065-fix_ryobi_wipper_snipper_modelHow to fix my Ryobi Wipper Snipper - Model# RLT30CD? Hi, I having been using the bump feed and all of sudden its not bump feeding. What should i do about fixing this up? Cheers Clint BairdTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3329998-will_start_amp_idle_fineWill start & idle fine. Will not accelerateTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3519193-broken_flexible_shaftBroken flexible shaftTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t1099117-ryobi_gas_trimmerI prime my ryobi gas trimmer. It starts for about 5 seconds. I prime it again and it does the same thing. It never runs more than 5 seconds.Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3490854-am_looking_ryobi_brush_cutter_partsI am looking for Ryobi Petrol engine powered brush cutter parts The carburator has a rubber bubble thing that you use to bleed it with and mine has perished,so I need to buy a new one . can you please assist .Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3417132-gas_hose_came_apart_in_ryobi_trimmerThe gas hose came apart in my Ryobi trimmer Model# RY30002A. How do I put in a new gas hose and filter into the tank? There is a little hole on top of the tank that is almost inaccesable and there doesn't seem to be any way to do a replacement. By...Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3394077-ryobi_pbc_3046ye_brushcutter_wont_runMy ryobi pbc-3046YE brushcutter wont run. When I start with choke it races for a few seconds then cuts out, if I get it started without choke it idles briefly then cuts out, if I try to accelerate it cuts out.Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3380078-magneto_gap_in_mm_30ccHi, What is the magneto gap (in mm) for a 30cc Ryobi trimmer? Thanks in advance.Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3367727-pull_rope_came_loose_get_housingthe pull rope came loose, how do i get the housing off to replsce it? The edger is a ss30 model less than a year old.Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3341899-2_gasoline_inputs_walbro_carbratorHave 2 gasoline inputs to my walbro carbrator. The one on the bottom closest to the diaphram side leads to the prime botton. The one on the otherside leads directly to the gas tank. When the prime button is pushed gasoline flows out the hole in the...Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3328369-change_head_ryobi_weedeaterhow do I change the head on my ryobi weedeaterTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3217302-no_air_filter_ryobi_c430_grassthere is no air filter on my Ryobi c430 grass trimmer. Is this normal?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3311007-unable_hold_drive_shaft_remove_spoolUnable to hold drive shaft to remove spool shaft. is there a special toolTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3297835-engine_stumbles_shuts_off_when_throttleengine stumbles and shuts off when throttle snapped openTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3293264-ryobi_725r_upper_drive_shaft_twistedI have a Ryobi 725r.... upper drive shaft has twisted off at the top, and I need a replacement. But can only find housing/shaft combo. Only need the shaft....any guesses?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3207833-trying_replace_line_in_ryobihello i'm trying to replace the line in my ryobi weedeater am i at the right site?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3198735-just_broke_piece_off_bumpi just broke the piece off where you would bump to get new string. So i went to the store to try and get a replacement they did not have one but they did have a whole new housing. So i am trying to get the old one off to get the new one on and i am...Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3198482-lost_compression_replaced_clutchI lost compression. I replaced the clutch and the housing. how do I get back top center?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3019949-gas_lines_cracked_not_no_gomy gas lines cracked and i do not no where they go and i dont no how i go about troubleshooting itTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3030465-ryobi_2800r_gas_trimmer_adjust_carbtrimmer will start but will not run when 1/2 choke is removed. I only see a single plastic button on top of carb with a slot in it but it does not seem to turn. Is this a limiter cap and if it is how do I remove to adjust mixture?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3084539-fuel_linesI rebuilt the carb,put new fuel lines on , according to the details on this website, and still have the same problems,it only runs on full choke and half, but when i throddle the ryobi it stalls. Help!!!!Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3111975-put_new_pull_cordhow do you put a new pull cord on?Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3156854-place_back_spring_new_ropehow to place back the spring and a new ropeTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3171911-aparthow do you take it apartTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3162662-pull_string_from_ryobi_cs_30I can pull my string from a ryobi cs 30 and it wont go backTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3150442-wont_startit wont startTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3108463-small_part_fell_out_in_grass_find_fiThe 0.08 nylon string comes out through a 1/2" metal grommet. There is one on each side of the spinner. It is only held in by friction. One of them fell out while I was trying to add more string. It fell in the grass and it is aluminum so I can't...Tue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3109983-sould_fuel_screw_setting_aswell_aswhat sould the fuel screw setting be aswell as the aircorrection screwTue, 22 Dec 2009 16:55:32 GMThttp://www.fixya.com/support/t3092529-carb_settings_ryobi_765rWhat are the carb settings on a Ryobi 765R???Tue, 22 Dec 2009 16:55:32 GMT