20 Most Recent Whirlpool GC3NHAXVY Stainless Steel Side by Side Refrigerator Questions & Answers

Whirlpool Refrigerator GC3NHAXVY01 Parts List

The frige does not cool your water, it only filters it. The temperature of the water depends on mains water temperature

When the filter is changed it needs to be filled, hold down the dispencer for about 2 min if still no water then try to run it with the bypass in place (small blue plastic part that came with the ref) That will tell you if the filter you are putting in is bad or if it is a pump issue with the ref.

http://www.partselect.com/refrigerator+whirlpool-filter-removal+repair.htm

Hi,

Here is a tip that I wrote about the reasons why ice makers do not work.

Ice Maker Problems and Ice Maker Troubleshooting

heatman101

Sounds like the drain is blocked or the IceMaker is overflowing/missing the tray.
Eric

Due to being less than 1 year old , you need to call a Whirlpool factory authorized service center for repairs . This repair will need to be done under warranty . You could try unplugging for a few minutes and then plug back in to reset the electronics .

down in the front grill at the bottom of the fridge you will see the filter and just the the left of it you will see a button. push the button in and that will pop the filter out a bit. pull it out and put the black cover that was on your old filter and put on your new one. then just push it in

The red light is part of the Ice Maker sensor system and does not determine cold setting. If it is cooling at all then I would check the coils for frost buildup and trouble shot the defrost components, no cooling at all could be compressor, thermostat, or defrost control related, Eric

CHECK FOR CRACKS IN LINE

You are correct. Same as refrigerator temperature.

Check the control panel or display on the refrigerator for any error codes or indicators that might suggest a malfunction. Reset the control panel by unplugging the refrigerator for a few minutes and then plugging it back in.

The Whirlpool WRB322DMBM01 refrigerator model typically does not have a dedicated water filter for the ice maker. Instead, it relies on an external water filtration system or an in-line water filter that may be installed in the water supply line connected to the refrigerator. Here's how you can check for and change the water filter for your ice maker: 1. **Locate the Water Supply Line**: Trace the water supply line that connects to the back of your refrigerator. The water supply line is usually a flexible plastic or metal tube that runs from the water source (such as a water pipe or faucet) to the refrigerator. 2. **Check for an In-Line Water Filter**: Look along the length of the water supply line for any inline water filters. These filters may be attached to the water line using compression fittings or push-to-connect fittings. They are typically cylindrical or rectangular in shape. 3. **Inspect the Filter**: If you find an in-line water filter, inspect it to determine its type and condition. Some filters have a label indicating the brand and model number, while others may have a date or indicator showing when it was last replaced. 4. **Replace the Filter (if Necessary)**: If the water filter is due for replacement or is visibly dirty or clogged, follow the manufacturer's instructions for replacing it. This typically involves turning off the water supply, disconnecting the filter from the water line, and installing a new filter in its place. 5. **Flush the System**: After installing the new filter, flush the water system to remove any air or debris. Run water through the dispenser or activate the ice maker to purge the system of any trapped air or loose particles. 6. **Monitor Performance**: Monitor the performance of your ice maker and water dispenser to ensure that the new filter is functioning correctly. It may take a few cycles for the water system to fully adjust to the new filter. If you cannot find an in-line water filter connected to your refrigerator's water supply line, it's possible that your refrigerator does not have a built-in water filtration system for the ice maker. In this case, you may need to consider installing an external water filtration system to improve the quality of your ice and water.

Delete To replace the LED light in your Whirlpool WRSSDHW08 freezer, follow these steps:

1. Unplug the refrigerator to ensure safety.
2. Remove all the items from the freezer to give yourself more room to work.
3. Locate the light cover inside the freezer. The LED light should be underneath this cover.
4. Carefully pry the light cover off using a flat-head screwdriver or your fingers. Be gentle to avoid damaging the cover.
5. Once the light cover is removed, you should see the LED light module. It may be held in place by clips or plugs.
6. Disconnect the power supply to the LED light. This may involve twisting or pulling the plug from its socket.
7. Remove the old LED light module from the freezer.
8. Purchase a replacement LED light module from the Whirlpool website or an appliance parts store. Make sure to get the correct part number for your specific refrigerator model.
9. Install the new LED light module by connecting it to the power supply and placing it back into its slot in the freezer.
10. Replace the light cover by snapping it back into place.
11. Plug the refrigerator back in and test the new LED light.

If you have any trouble replacing the LED light or if you are unsure about any steps, consult the user manual for your Whirlpool refrigerator or contact a professional appliance repair technician for assistance.

https://www.appliancepartspros.com/repair-help/whirlpool-refrigerator-wrf535smbm00-repair/wrf535smbm00-ice-maker-not-making-ice.html Whirlpool Refrigerator WRF535SMBM00 Ice maker not making ice Causes of a bad icemaker cycling thermostat can include electrical malfunctions, temperature sensor issues, or wear and tear. Symptoms of a bad icemaker cycling thermostat may include: Inconsistent ice production. The icemaker not cycling properly.

HOW-TO: Whirlpool Refrigerator WRF535SMBM00 Ice maker ...

There is no water filter.

Where is the filter for water for ice maker located on

JustAnswer https://www.justanswer.com > Appliance Repair Jul 23, 2018 - This particular model does not have a filter built into it so that is why you can't find one. If you wanted to add a filter, you can get an in- ...

Sounds like the evaporator fan is not running. Pull the inside of the freezer back off to expose the motor and replace it.

See page 11 troubleshooting of manual. This problem is discussed there. Whirlpool GS5VHAXWY - 25.6 cu. Ft. Refrigerator Use And Care Manual (Page 11 of 37) ' ManualsLib