20 Most Recent
Questions & Answers
Error c44 call for service
abnormality after abnormality judgment: The temperature of the fuser
roller has exceeded the range of control or does not even reach the
can try going into (08) mode by holding 0 and 8 while turning on the
copier. Once the copier starts up key in 400 and press start, input "0"
and press interrupt. Try rebooting the copier, if this doesn't clear
that call for service then you are going to need to get work done on
on May 17, 2019
1) use toshiba original toner cartridge
2) replace toner sensor
3) wiring harness
on Jul 22, 2018
How to ready toner not
Please switch off the machine, while holding down0+8 buttons switch the machine on.
When machine starts and displays [ad] input 695 and press the start button.
Input 0 and press interupt and energy saver.
Input 971 and make sure that value is 3, if it is not input 3 and then press interupt then energy saver buttons.
Switch off the machine, wait awhile then switch the machine on.
The problem should be sorted out,
on Apr 29, 2017
My Toshiba e studio 167 is showing a c44 error
the c44 error is an error in the fuser if you know how to take the fuser out check for toner buld up on the thermistors.. the sensors with the thin strip that presses against the hot roller gets toner build up and cant read temp properly.. you could also try turning machine off and then on whilst pressing 1 3 and * buttons together this might reset it temporarily for you.. Good Luck A
on Dec 02, 2015
Error code f 14
Hello; I believe your copier need PM that's mean you need replace drum, cleaning blade and developer at lease, after that doing simulation as follow;
press "0"&"8" key while turn on, enter 251 then pree enter, press 0, press enter. turn power off and back on again.
on Aug 18, 2014
Not finding what you are looking for?