20 Most Recent
IOGear (GMFPSU21W6) Print Server Questions & Answers
GMfPSU21W6 usb print server support windows 7
When I upgraded from XP to Windows 7, Iogear tech support told me that they had no intention of offering Windows 7 support for my GMFPSU22W6, so I dumped it and bought a D-Link DPR-1260 instead.
5/20/2010 5:00:16 PM •
IOGear...
•
Answered
on May 20, 2010
IOGEAR GMFPSU22W6 PRINT SERVER not being seen by
For the GMFPSU22W6, there's two possible reason why it's not being seen by the MFP Control Center. First, the MFP Control Center was properly installed, second, the Print Server is not working correctly. To resolve this problem, please try the solutions below:
1. Uninstall/re-install the MFP Control Center.
2. Reset the GMFPSU22W6 by holding down the "Init" button that's located on the right side of this device. Hold it down by 10 seconds and then unplug the power adapter while still holding down the "Init" button for another 10 seconds.
3. Resealse the button and turn it back on by connecting the power adapter to it.
5/2/2009 12:49:13 AM •
IOGear...
•
Answered
on May 02, 2009
4156 error
go to IOgear web site for firmware if available.
Http microsoft com downloads
Please provide:1-OS o Sistema Operativo2-Did your card comes with a installation CD ?Also remove :it again, turn on turn off on the PC, then put the card again but make sure to clean the plated connectors with at least alcohol and seat gently but hard enough to the card slot.3-Power back the PC and wait until the system recognize the card.4-After if everything goes well check the card driver if is newer than the CD.Post back!
Not finding what you are looking for?