20 Most Recent Omega 9000 Juice Extractor Questions & Answers

REMOVE BOTTOM AND TRY ADJUSTING
RESET BUTTON BY TWEAKING SMALL
SCREW ON BUTTON HOUSING. TURN
EITHER WAY TILL YOU HAVE LONGER
RUN TIME.

It could be the fuse is bad and the cord is also bad too. The fuse inside of the juicer and the power cord will both need to be replaced.If the motor has quit working then you will have to buy another juicer.

if put togeather correctly and followed manual send it back

no we dont sell anything here. try google of the manufacturer

1. test for power at female end of cord? (eliminates, breaker, socket, cord, plugs, all wiring to appliance. I think this appliance is hard wired at the connection, so you may need a non-contact tester.

https://www.youtube.com/watch?v=tqrGy2TJ5M8

https://omegajuicers.zendesk.com/hc/en-us/articles/360003983592-VRT330-or-VRT350-Juicer-stopped-working-Juicer-won-t-turn-on-No-power-to-my-juicer-

go to me

Omega Juicers Repair Form This is a link to the official repair form for all Omega Juicers.

Never oil a power switch. Sounds like a defective switch and if others have the same problem go to the manufacturer website and look for a possible recall or solution.

i have no solution thats why i am asking where i can purchase a pulp collector

Hello! Welcome to FixYa!

Sir/Ma'am which specific model and type of Omega Juicer you are using? Is it Centrifugal Juicer, Pulp Ejector Juicer, Citrus Juicer or Masticating Juicer? Is there specific thing happens when you switch on it like it vibrate or something or it shows no response? and when you tried it on the outlets which problem they diagnosed for it. Have they told you the solution of the problem?
Please let me know about these so i can provide you assistance that what should you do,
I am here to help, Waiting of your response.
Thank You

Unscrew the bottom cover to expose the electrical cord. Check voltage if coming from the electrical cord by using a tester.If there is power, look for a a thermistor or a fuse and test if it is broken.

It is quite possible that the motor bushes , bearings or the jar bushes are worn out as this will make the motion of the high speed motor to allow the friction to work through therby making the whole assembly to vibrate.
You need to check this by observing the shaft play, it will be very minute but is enough to cause problems.