http://www.fixya.com/support/p67831-ma_audio_hk4000d_car_audio_amplifierSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 21 Aug 2008 06:46:51 GMT80http://www.fixya.com/support/t946971-one_morei figured out what i did qwrong i hooked my remote into my speaker and my speaker into the remote section and its not working properly now its givein me some loud noises and speaker just goes off when it feels its needed ......how much would it cost...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t931999-same_wayits connected the same way it was before i took out the other amp how do i test the cap to find out if its defective or notThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t931972-ok_didaight i noticed that my 90amp fuse running under the hood is blown i relplacd and it blew within 30 sec and my capacitor got hot instanly ,,,,,,,,,,,,,,whats that meanThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t931306-thankswell im going to by a meter as soon as sears opens up how do you know if your amps blown and needs to be returnedThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t930268-amp_powering_allwell i have a brand new amp ma hk401sx series and after i installed it i noticed that it has no power at all being feed to it that i kow of no leds or noise at all i hooked up the remote to it and i have no problems gettin a led o the remote only can...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t611969-ma_audio_hk4000d_please_help_meI have a MA Audio HK4000D the protect light is on i know the speakers are good wires are good , on the amp ,the volt meter and the temp gauge and fans come on but no boom, i have FOUR JL Audio W7" 13'' i pull my sub off TWO 1800 kenwood d class mono...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t228021-enoughi am looking at 2 15'' audiobahn immortal series subs and i 2250 rms max quad 2ohm and i need to know if this amp will power these subs? and if so how many rms to each sub?Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t183441-no_se_como_bridgear_un_ma_4400_si_es_decomo l ago para bridgear un ma de 4400 si es de un canalThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t162010-ma_audio_hk802sx_4400w_ampI bought this amp like 2months ago and had problems with it, sent it back to ma audio for replacement, when i got it back it worked fine for 2 weeks then i decided to plug the remote bass control they sent with it up and as soon as i did the bass...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t128482-ampI Have a brand new MA audio 4400 watt amp. It turn on LED's come on digital read out work cooling fan come on but no power going to the sub. I tested the RCA's there good. The power turn-on is good to. Tried it with different subs and still...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t158267-ampI have my amp set on low freq only but i still have vocals coming through my subsThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t119645-amlifier_not_workingHi,I have Pioneer DEH1530r and I just bought amp Crunch mxb2175 and Pioneer sub. I connected all wires( power lead to + battery, RCA 2 cinch, black earth lead) but amplifier green led never started on. I didnt connect remote turn on lead. I...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t120032-500_1_turns_off_high_volumesi have a jl 500/1 that was working great, then all of a sudden it has started to turn off and on at high volumes. its fine at low volumes. any ideas?Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t111137-protection_light_commingWhen I connect the RCA's to the amplifier and try to turn on the amp the protection light is turning on. I would like to request a schematic for this particular amp and if not can I find out how to get them. The amp is a Jensen KA 5 car amp 4...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t115301-eclipse_xa1000_protect_modeI recently replaced my two 12" subs due to a problem in the voice coils. It seems they were pushed beyond their limits and they broke. These I had installed in parallel and enclosed in a dual bandpass box. I replaced them with a pair which I...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t116156-smoking_amp_fuse_blowingOk im having similar problems as you seen up above. im not good with electronics as far as checking the B+ thing lol but my amps doin the same thing. i was intending to get my compacitor hooked up but i got set back b/c of money probs. So i had it...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t118004-ampI have installed a amp into a figerglass boat, the radio is new and is working. However after connecting the amp I have no sound. I feel that I have a bad ground, would this be the problem. And shall I connect the ground to the motor.... HelpThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t118349-audio_system_makes_extra_noises_popsAudiobahn Sub: AW1206T & Amp: A8002T subwoofer extra noise/pop i have also posted this under the subwoofer page since i did not know which part of my system is malfunctioning now i dont know if its from the amp or not but amp light is on &...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t118562-power_supplyif the amp is not getting enough power consistantly will the amp heat up because is working harder. if so would a cap solve the problemThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t117563-need_help_cooling_fanI have a Kenwood Excelon KAC-X301T with the powerslide and my amp is getting hot after about 30 minutes driving...It seems as if the cooling fan isnt working...I mean its on, but the amp is just waaay too hot...And the amp goes in and out after...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t13505-new_receiver_preamp_output_high_volumeI have a new receiver with a preamp output, high volume, and I want to feed that into my power amp. Do I need to regulate the signal into my amp with a preamp?Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t13508-drive_more_two_speakers_one_stereoHow do I drive more than two speakers with one stereo amplifier?Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t102380-radaceI need repairs a burned amplifier but not that colors are those of resistance since they is burned if they could send a manual to me of all the pieces that take to this amplifier thanksThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t102425-problemI am having trouble keeping my amp on when I turn up my stereo. I am running it in stereo setting on the LPF and I have 2x10" subs at only 250watts each. I want to know how I can diagnose this problem of the amp cutting out when I turn up the...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t102569-american_legacy_ii_la690_ampi want to know if there is any way you can bypass the overhaul (green light:power, red light:overhaul) because when ever i bridge the amp it shuts off and i don't want it toThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t102683-need_power_connector_boss_iq_3kd_1Where can I find a replacement power connector for a Boss IQ 3KD.1 3000W Class D Monoblock Amplifier. The screw loosened on the +12 terminal and it melted the terminal and the plastic.Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t103895-amp_isnt_putting_out_any_soundMy amp just up and quit and now it won't put out any sound. It will power on but that is as far as it gets and the LED light never turns on now. any help would be appreciatedThu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t109619-ohm_load_bestis the lowest ohm wire configuration gonna get the best sound out of your amp? ive got a 1 ohm stable amp, is that what i wanna go with?Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t109622-parallelsince were on the topic of wiring... does it make a difference if, when wiring in parallel, you have the wires coming off the subs, then connecting to one wire that goes to the amp? As opposed to have the wires coming off the subs and meeting at the...Thu, 21 Aug 2008 06:46:51 GMThttp://www.fixya.com/support/t109625-y_put_amp_remote_gain_xovrHave one gain/crossover control next to driver's seat, was thinking of putting one in the trunk near the rear window, can i just get a y-adapter with the cable's terminal on it and it will work? or will the system get confused when two are plugged...Thu, 21 Aug 2008 06:46:51 GMT