http://www.fixya.com/support/p64838-frigidaire_fah085n1t_air_conditionerSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comFri, 08 Jan 2010 11:04:33 GMT80http://www.fixya.com/support/t3097826-replacement_power_cordreplacement of power cordFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t2628765-bought_frigidaire_ac_says_removebought frigidaire AC. Says remove INTERNAL packaging. I see styrofoam inside the unit but no way to get to it. Is it suppose to be there? I ask becAuse the side the syrofoam is on is near the air vent and does not blow cold air out as well as the...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t656977-no_cold_airUnit will turn on but doesn't feel like it is blowing cold air. Have the fan on cool and temp all the way down at 60 and just blowing warm air. Wondering where i might start. Can't tell if compressor is running or not. doesn't sound like it is...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t2405315-internal_packaging_needs_stayI just bought a Frigidaire FAM157S1A window AC. After it is already out of the box and you remove the base from the cabinet, the instructions say to remove all internal packaging from the unit. The picture is unclear, but I can make out some plastic...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t1011120-not_removing_humidityFrigidaire FAH085N1T cools OK but room is "clammy." Is the unit too large? Room is 138 sq. ft, 8 ft. high. Various calculator sites recommend between 6000 and 9000 BTU. This one is 8000. Is it too big? What else could cause inadequate dehumidifying?Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t212204-furnace_burners_wait_long_comeFurnace wait too long to come on and then comes on with big booh and after 5-10 minutes burners and pilot goes off together. I already change the thermocoupler. any advise? Mitchell Manuf. Model 75-AGCF s/n- f1-113Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t233774-hisense_air_conditionercompressor on air conditioner runs for 5 seconds then cuts out,after a few minutes cuts back in, runs for 5 seconds and then turns off airconditioner.after minute or two cuts back in compressor runs 5 seconds cuts out and so onFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t269724-burners_come_go_out_amana_80ssewhen thermostate turned up, fan comes on and the burner lights then goes out.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t270444-helpMy problem seems to be my furnace works fine if i manually cold start it but once my unit gets hot it wont restart the jets wont stay lite and the fan will not come on but if it hasnt been running and is cold its starts fine ???Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t282059-usb_pc_webcami connect a web cam in myy pc but my windows doesn't know it , i need a pilote in my computer , i have a fijing web cam i tru several usb cam driver but doesn't workplease can u help . thanksFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t282344-heater_sounds_badHelp diagnose heating unit sounds.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t296159-intertherm_furnace_not_working_rightnot sure what is wrong with my furnace....but when it is on but not running...it emets (sp?) heat and smells of burnt dust. Has been working properly until yesterday (12-11-07). Can someone please tell me what might be wrong with it....Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t298309-hse_manuali am in the search of HSE manual for Central HVAC project div.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t302104-no_auto_shut_offI had an older Air comp. with a bigger but damaged tank, and i bolted this electrc. motor and pump to the little smaller but no problem Newer Tank (campell also) this one have a worn cylinder, everything works Good now ,But the Auto Shut-off switch...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t304329-duo_therm_air_conditioner_mod_59136_331Unit is installed with 120 volts to the unit and 12 volts dc with polarity checked. However there is no readout on the thermostat. Any suggestions?Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t313804-newair_mod_acp_1600e_h_seriesThe most amount of heat I can get out of it is 64. And the thrmostate goes to 90.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t313904-portable_air_conditioner_heaterwont throw out heat, the hightest I can get is 64 even when I set it at 90. Thank You: LarryFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t323229-unit_will_not_startAFTER REMOTE DROPPED AND THEN BATTERIES REPLACED IT WILL NOT STARTFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t325254-frigidaireHeater is not working. Ignitor goes on. Fire is next, but it does not stay on so the house is not heating up. Any ideas?Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t332319-wiring_thermostatRuud heater model (-)HQA(-) five wires coming out of the unit. Two black labels G and W. One yellow wire coming from the 24v transformer. And one purple and one brown. Need to know how to wire just the heater without the air unit.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t338034-centrex_airconditioneri have two centrex aircons, the one works for a few seconds then stops working and shows an error e4 on the screen. The other one works but wont blow cold air, only warm air. Please help me.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t346854-coleman_furnace_questionI have a Coleman furnace questionFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t365519-ge_zoneline_heat_pumpit is not running and it beepsFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t365999-ge_zoneline_2100_heater_ac_heat_doesntI have a couple GE Zoneline 2100 units with different problems: One unit blows cold/hot air at the same time when set to heat. It doesn't ever shut off either...I have to unplug it...either in heat or cool mode. The other unit was working alright...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t368159-manual_operation_split_systemPLS ADVISE WHERE MANUAL PANEL IS ON AIRCONDITIONER TO OPERATE WITHOUT REMOTE CONTROL, THANKYOUFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t368524-air_conditioner_cleaning_procedureHi there, I need instruction on how to clean the above product, any ideas? thanks for your time.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t369579-split_air_cond_faultI have a split air cond with fault P 05 on the display what does that represent? Thanks Peter v.Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t378154-fuel_pump_relay_locationsCan anybody tell me the locations of the fuel pump relays for a 2000 3.0 V6 Stype and a 2003 S Type V8 ? Greetly appreciated !!! Thanks, MikeFri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t382939-zoneline_3100I have a zoneline 3100 , and it seems at a certain temp. the unit shutts down , no fan , no heat . After a few days the unit will begine to run normal again . I have attempted to have it looked at by several heating and plumbing co. but no one wants...Fri, 08 Jan 2010 11:04:33 GMThttp://www.fixya.com/support/t395769-panasonic_split_system_air_con_cs_cuStopped the other day in the storms arond here. Have done troubleshooting checks and found the timer indicator blinking. Did this check to find a code H11. Any help on whats wrong would be greatly appreciated. System is in as new condition as well.Fri, 08 Jan 2010 11:04:33 GMT