20 Most Recent
Canon PIXMA MX300 All-in-One Printer Questions & Answers
Canon Pixma mx300 printer has paper jam
Canon Pixma MX300
- new cartrige for Black ink
- can scan
- can photocopy documents
BUT can't print documents from my MacBook eventhough the paper feeds and goes out at the other side
Printer offline or does not respond
oh my friend.
just click the printer icon
1)click start on task bar.
2)go to settings or printer and faxes options.
3)in there you can see the printer icon
4)just right click that printer icon
5)there u will get the option
6)beside of which option there is a tick mark that is applied/enabled.
7)if there is tick mark beside the pause printing and offline option.
8)just click that option and that tick mark will go away and it will start working.
How to reset canon pixma
The waste ink absorber is full and is triggering error 5B00. To reset the error you need to replace the ink absorber. You may find a cheaper ink absorber kit on Ebay or Amazon.
We are getting a message "waiting on report" when trying to fax
I experienced this problem when "Fax Setting -> TX Setting -> Print Report" is configured before you send out the fax.
After your Fax was sent, and the message "Waiting for report" appear forever and does not leave.
It
is because your INK Level is Low and your have set "Fax Setting ->
RX Setting -> Auto Print ON -> Print when no ink OFF", and so the
report will not be printed out due to ink level is low.
Solution:
Configure
"Fax Setting -> RX Setting -> Auto Print ON -> Print when no
ink to ON", and the report will be printed out immediately, the message
disappear.
Cannon f189402
Go to the canon website and download the program from there for your printer, the programs are updated on a regular basis so you will get the latest version.
ERORR
Hi, please try this, you need to start your printer. While your printer is starting hold the stop/cancel key. Then the lights should flash. Push the colour copy button 4 times. Turn Off printer immediately. Power up printer and check if the issue is resolved.
ERROR CODE 5100
This particular error had stumped me for a while, but I finally found the cause. As others had pointed out before, it can have alot to do with some obstruction in the print path, the gears, or ink on the clear plastic encoder strip. You're on the right track - I found the the purge cap (the white sliding mechanism that the print head parks to when it's not in use) was not lubricated well enough from factory. If you lubricate the sliders with some white grease (don't get it on the small wipers or the black caps) the mechanism can now slide more freely, and the unit can park the head properly without giving you the dreaded head homing error 5100 (or E-2-2 on the LCD display) Keep in mind that this repair will probably require you to remove the right panel off of the printer to gain access to the purge mechanism. There are two screws behind the printer, and two in front for each corrosponding side panel (the front screws are behind the grey front panel of the printer - open the top cover to see the clips which hold the front cover on) Hope this helps some of you out
Not finding what you are looking for?