Frigidaire 20.6 cu. ft. / 583 liter Upright Freezer FFU2124D - Answered Questions & Fixed issues

On electronically controlled units, a light out issue may alert you to a failure situation,(minor).. Replace the bulb and see if that was the fault I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

Normally, laying a refrigerator down will cause any debris or sediment to float through the tubing and eventually end up in the filter drier which contains silica beads to absorb moisture. Debris will then plug up the drier. A technician will be required to evacuate the sealed system. He will then cut out the old drier and braze in a new drier and recharge the system. There is usually no guarantee that this will fix it because if the debris is large, it may clog a capillary tube and render the unit un-repairable. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

I had this same issue and all repair service could do is stop beeping. Finally I sold my refrigerator for cheap and got a new one.If you don't have the proper equipment to adjust door and seals. better call a repair service and hope they in your case, should help.

Hello friend, thanks for your post! I see that your Frigidaire freezer had a power surge and you're asking what could happen. If your appliance had a power surge it could cause an issue within the board or wiring harnesses. Is your appliance giving any error code or beeping? If so, could you advise what it currently is doing? I look forward to providing you any assistance. -Matt

Replacement parts are available here. 03 Door Parts for Frigidaire FFU2124DW2

Hello Friend, this is Z. I am happy to assist you! I see that your question is listed under Frigidaire Upright Freezer; however, please help me understand the issue you are experiencing. Is your freezer showing error code OFF? If so, the temperature control is in the OFF position. When this occurs the temperature control turns off the compressor, but does not disconnect the power to the light bulb or other electronics. Let's try activating your freezer by pressing the UP arrow until display shows "4" or desired setting. Please allow 24 hours for temperature to stabilize. For future reference you can lock the control to keep from accidently changing the temperature setting. I hope these troubleshooting tips help you in some small way. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your freezer status has changed successfully.

Hello Friend, thank you for your question! From what you have described it sounds like the compressor is cycling on when cooling is necessary and cycles off when the temperature inside your freezer has reached the set temperature. This is normal. If you feel that there may be some other issue occurring, feel free to go to the manufacturer website where you can easily locate a service provider in your area.

The motor not always a sound and if they do run constantly you will have a fire on your hands. Open the door for 45 seconds and then close it .uu will find the motor kicks in and runs for 1 min to 3 minutes.

Check your door/'s are sealing if they leak u will get freezing occurring in the bottom and around the door will have allot of condensation. good luck all the best . P's always lay liquid bottle on their side as they will cool quicker and be better on electricity.

My green light stays on all the time unless I open the door and it needs to get back down to temperature. The red light will come on then and return to normal after 30 seconds to a few minutes if on a hot day. Good luck hope I could help

January 2001 and july 2003 is when it was sold between. Some new old stock is still getting around. Shocking model for faults . But most were easy fix

3 seconds or as long as it takes to get back to temperature.

Hi there. I really think it could be a thermostat or a small fault. But jump on Google to look for faults with that model. Let me know how you go

Good Afternoon Friend, I understand that you want to know if the green light has to be on at all times and the temperature set to normal on your Frigidaire freezer, model# FFU2124D. The green light will always be on. This is letting you know that there is power going to your freezer. You do not have to leave to temperatures set on normal. You are able to choose any temperature that works for you and keeps your food frozen. When changing temperature settings, turn the knob slightly in the direction you want, and wait 24 hours for temperatures to stabilize. If you want to change the temperatures more, again wait another 24 hours after changing them, for the temperature to stabilize. Hope this is helpful. -Best Regards- WP

Pull it out of the power point for 1 min
done

The red light and the audible alarm both come on when the freezer gets warmer than the alarm point... unless you disable the audible alarm with the rocker switch

Maybe the ice maker?

Hello Susan, thank you for your post! Did your freezer previously experience a power loss? If the temperature of food rises to an unsafe level, the buzzer will sound and the red light, if equipped, will also glow. First, deactivate the alarm to your appliance by unplugging it or flipping the household circuit breaker. Wait approximately ten minutes and then turn on your freezer. After deactivating the alarm and your freezer has run approximately four hours, the red light/alarm should go off on its own. If the red light/alarm continues to stay on, your freezer may possibly have a communication problem with the control board, temperature control or a wiring harness. If this is the case, I would recommend connecting with an experienced technician to determine the underlying cause.

A few suggestions are 1. Turn down the fridge portion a little and colder air should redirect into the freezer part 2. If it is an older unit sometimes defrost it , unplug it and turn it upside down for a day or so (this moves some of the corrosion inside the pipes). Turn it back up and plug it back in .

the defrost timer and limit switch (its clipped to the top of interior coil) needs replaced If you need further help, I’m available over the phone at https://www.6ya.com/expert/rick_4ed9a6c8e57209e6