20 Most Recent Jenn-Air 24 in. JDB1080AW Built-in Dishwasher Questions & Answers

I am pretty sure that it means your last load was interrupted somehow and it needs to run its course in-order to start a new one. So, all you have to do is un-lock your washer, set your knob to a little before the drying process, and let it run its course and complete on its own so that you may start a new cycle.

Check to make sure that it is completely level. That will usually handle this. The drain feature is the simplest on the machine and this usually happens when a castor has settled or the floor sags under the unit.

Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Water will not drain out

heatman101
..

You appear to have a defective control board. You should have a Jenn-Air tech come out and test the control board. How old is the machine? Usually those control boards run $250+!! Compare the cost of the machine to the repair total.

yes mam please check the water pressure and remove the inlet hose and clean the inlet water filter then clean the arms.

You should try an easier site. Go to www.applianceart.com and they have a bunch of options for you to order and they are shipped right away. I think dishwasherpanels.com is them too.

can you please provide some details about your machine..

the model and the part # please..

Thanks

POSSIBLY CONTROL BOARD BUT WE CAN NOT GUARENTEE IT SINCE WE CAN NOT DO THE TESTING NEEDED

The accumulator filter is below the spray arm radiant shield, guard and wash impeller and above the wash motor and pump. See part 7 on the diagram: https://www.partselect.com/Models/JDB2150AWP/Manufacturer/1/Sections/PUMP-AND-MOTOR/?ModelID=89671&ModelNum=JDB2150AWP&mfgModelNum=&ManufactureID=1&Selected=55866&Position=2&mfg=Maytag&Type=Washer&Mark=2 . There is also an over-pressure filter on the dishwasher feed tube. See part 2 here: https://www.partselect.com/Models/JDB2150AWP/Manufacturer/1/Sections/WATER-DISTRIBUTION-ASSEMBLY/?ModelID=262050&ModelNum=JDB2150AWP&mfgModelNum=&ManufactureID=1&Selected=55865&Position=6&mfg=Maytag&Type=Washer&Mark=6 . I hope this helps. Cindy Wells

Contacts in manual may also help. http://kitchen.manualsonline.com/manuals/mfg/jennair/dw860.html

Check the connection to the drain tailpiece from the dishwasher under the sink and make sure the clamp hasn't slipped off and is tight. Check the drain hose from the dishwasher and be sure it's not split or damaged. Check the drain spur on the drain tailpiece and see if it's corroded or leaking. Check the trap under the sink as well and make sure it's not leaking.