Top 20
Whirlpool Ultimate Care II LSQ9564J Top Load Washer Questions & Answers
I keep getting a 17755 error code on vag com
Have you cleaned the water filter out and checked the waste hose first? Make sure you only use a quality detergent as cheap pound shop stuff can rot the sensors, and foul up the camshaft.
12/29/2017 12:09:03 PM •
Whirlpool...
•
395 views • 0 helpful votes
Why does my older whirlpool washer fill, agitate, then stop?
The motor is possibly overheating due to dry bearings, causing the thermal overload to open (it re-closes when the motor cools down).
SOLUTION:
Get some oil onto the felt pads around the plain bearings each end of the motor-where the shaft comes out, you'll be able to dribble it in; at the covered end if you can't prise the cover off, make a hole in it with a philips screwdriver and a sharp 'tap' with a hammer.
I like to use silicon oil but car engine oil would be ok.
7/6/2014 12:28:47 PM •
Whirlpool...
•
397 views • 0 helpful votes
Why does my machine not wash as good as it used to?
Water temp changed? Different detergent? Overloading enough to prevent proper agitation? All these can affect the performance. Also, if drainage is slow due to clog or weak pump, it might not rinse well, leaving soapy residue as well. Whirlpool pumps are pretty cheap and easy to change, usually, should that prove to be the source of your trouble. But look for simpler causes first.
6/27/2014 2:26:25 PM •
Whirlpool...
•
146 views • 0 helpful votes
Washer spinning problems
I want to help you, but I need more details.
Most commonly this type of problem is caused when the washer is overloaded and the motor or belts get worn out.
4/24/2014 1:30:50 AM •
Whirlpool...
•
71 views • 0 helpful votes
Not finding what you are looking for?