20 Most Recent Whirlpool Ultimate Care II LSQ9549L Top Load Washer - Page 5 Questions & Answers

It could be the door lock mechanism is beginning to malfunctioning. It is supposed to enguage before the high speed spin.

Whirlpool... | Answered on Apr 27, 2014

our washer smelled like burning and reset button totally fixed it, it was under screwed down panel in back

Whirlpool... | Answered on Apr 26, 2014

I had the same problem yesterday, the tech online said that if you look closely there are 4 little thin rectangle holes... it may not look like holes since the manufacture fuses it with hard melted plastic to keep you from yanking it off. I used a flat edge screwdriver and pounded it in with a hammer (like using a chisel). Punch th 4 holes so the plastic seperates from the dog assembly. Place on floor, stand on it and pull straight up!

Whirlpool... | Answered on Apr 22, 2014

Maybe loose switch

Whirlpool... | Answered on Apr 14, 2014

Could be the belt worn or pulley worn causing slippage

Whirlpool... | Answered on Apr 14, 2014

check water inlet value. also check that the hose is not blocked at the value where they screw on. there are screens that get blocked clean with old tooth brush

Whirlpool... | Answered on Apr 08, 2014

One possible cause.
Someone is pouring fabric softener in the washer's Bleach bezel.
Causing the bezel to become clogged and then overflow.

Whirlpool... | Answered on Apr 04, 2014

(1)Have the unit check for electric voltage to the element
If voltage going to the element and no heating
(2)Your heating element may be defective.
(3) Have it replace by qualified personel

Whirlpool... | Answered on Mar 21, 2014

I'd try putting the machine on a hot fill wash, max water level put in half a cup of baking soda when the machine starts to washer turn it off and leave it to soak overnight, then let it finish the cycle the next day. Also make sure you tip some of the hot water down the beach dispenser and clean all around the top of the machine


Whirlpool... | Answered on Mar 16, 2014

usually, an electric motor has a capacitor connected parallel to it whose function includes helping the motor start spinning. try replacing this with a new one. it looks like a small cylindrical can usually white or black plastic or aluminum metal that is about two inches in diameter and about 4 - 5 inches tall with a pair of wires snapped onto it. pull this out and bring it to a hardware shop when buying for a replacement.

Whirlpool... | Answered on Mar 13, 2014

usually, an electric motor has a large capacitor connected in parallel and one of it's functions is to help start the motor spinning. try to check this capacitor and replace it with a new one if defective.

Whirlpool... | Answered on Mar 13, 2014

sounds like the lid switch is faulty

Whirlpool... | Answered on Mar 09, 2014

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9549L Top Load Washer Logo

2,460 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts


Level 3 Expert

84949 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1479 Answers


Level 3 Expert

411 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Whirlpool Washing Machines

  • Whirlpool Washing Machines

Most Popular Question

water overflowing wont stop even when

  • Washing Machines