20 Most Recent Panasonic BLUETOOTH HANDS FREE KIT :unitsize PANCYBT100 Wireless Headset Questions & Answers

Be sure the the headset in in 'Pairing' mode.
When in pairing mode, the light should be flashing red and blue or have a steady blue.
The put most headsets in pairing mode, turn headset OFF, then hold the power button until it goes into pairing mode as discribed above.
Then you can discover it with your phone or PC. Pin (pass key) should be 0000 (4 Zeros) or try 1111, 1234, 9999

Unfortunately, Blackberry phones do not support a USB headset, even though both can connect to your laptop. You would have to use either a bluetooth or wired headset plugged directly into the Blackberry itself.

Good day. I would like to recomend you a company Rexsoft: https://rexsoftinc.com/This company can create any website which you need.

Sounds like oxidized contacts. If volume is a turn-knob, then wiper-track (inside potentiometer) is worn. If it's a PTM (push-to-make) standard button, the button contacts may be dusty/dirty/oxidized. Suggest you: buy a contact cleaner such as Servisol, open case, identify controls and squirt liberally to wash out any gunk. Move/press/wiggle scratchy one to help 'scrub' the contacts clean. If this doesn't help try have control replaced.

Use a splitter cable to allow both to use a single output. This is a description from Amazon : Hosa YMM232 6-Inch Y Adapter, 1/8-Inch Stereo Male-Dual 1/8-Inch Female

Check out this site http://www.bigrigstereo.com/harness_plug_and_play.html They sell harnesses for semi trucks like Kenworth, Freightliner, Peterbilt, Western Star, Mack and others. Largest stocking dealer for semi truck radios on the internet. Well worth checking out if you need a radio for your semi truck

0000 should be the default pass key.......

Wiring a fridge thermostat typically involves connecting the thermostat to the power source and the compressor. Here's a general guide for wiring a 3-pin thermostat:

1. Identify the Pins: The thermostat will typically have three pins labeled 4, 6, and 3.
2. Connect the Power Source: Pin 4 is usually the common (C) terminal, which connects to the power source. This could be the live wire from your electrical supply.
3. Connect the Compressor: Pin 6 is often the normally open (NO) terminal, which connects to the compressor. This allows power to flow to the compressor when the temperature rises above the set threshold.
4. Ground Connection: Pin 3 is commonly the ground (GND) terminal. This should be connected to the ground wire for safety purposes.

I recommend RadioReference.com, they have detailed lists from all over the United States. In addition to frequency lists, they also include live audio, HAM radio lists, licensing information and a lot more.