20 Most Recent Amana Haier AP125HD Air Conditioner - Page 3 Questions & Answers

Hi, Please hit the "constant fan" button until the "on" button is removed from your Amana screen. Thank you.

bad control board

blower capacitors or motor bad

you will need to call for service. if it needs freon you cannot recharge it freon is expensive and requires a license.

The cold that you describe may be just unconditioned air? If you are certain you can hear the comp operating for a couple of minutes, and then the heat starts, I would guess it is a reversing valve issue if it's a heat pump and it probably is. Or the control board acting up. I've had a lot of issues with the boards in the Amanda PTAC units. I can't remember how to configure it, but if you Google "Amanda ptac configuration", there is a lot of info online. May try a reset method first. Hope this helps!

copy and paste https://www.amanaparts.com/Shop-For-Parts/a4b1d693274/Model-ATB2232MRW00-Amana-Refrigerator-Parts?n=3

Self evaporating simply means there is a drain pan with a heater device installed that will evaporate and condensate that drains from the unit into the pan.

You do not need the external drain pan unless the unit makes more water than the drain pan and drain pan heater can handle.

switch thermostat to emergency heat. Call for service the unit should be under warranty. Be aware that using heating strips will cause your electric to go extremely high.

Empty the water pan. It not sealed so dont slosh it around. Mine did the same thing. Amana rep was an ***. Wouldn't give me an inkling of what to do. So i started to fiddle around. There was a lot of water in it Be careful. I brought mine to the tub and drained it for close to 2 min. Started right back up!

batteries in the right way? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

If this is a window unit, the tray drain is located at the bottom outside. It may be clogged, but also the unit may not have been installed correctly to direct water flow toward the outside drain.

All this means is that the Copeland monitor is sensing amp draw on the compressor but it is not detecting a Y signal calling for the compressor to run. If there is no problem with the contactor and equipment is running fine, check for the jumper wire that carries the Y signal over to the compressor monitor.

Goodman Industries has purchased Amana. So go to Goodman website for info. Without model number I cannot look up error code

You need to reinstall the software http://rollingskygame.com/run-3

What is -the outside?
Heat pump, gas, electric heat combination?
You may need to back track, double check the Honeywell configuration jumper or software settings for your type of heating used.

Try empting the reservoir located on the bottom back of the machine.

There should be a fan symbol on your remote control. In the "mode" control, there should be the following options.. Heat, cool, Auto and fan. If you select fan, only the fan will run. No heating or cooling.

Check voltage in , there could be one side of breaker burned causing only one side to come through. This happens on older main breakers frequently which messes up whole house.

look on the manufacturing plate