20 Most Recent Amana AAC051FRB Air Conditioner Questions & Answers


Hi, if your indoor evaporator coil is clogged with dirt, you need to remove the cover to expose it first. Shut it of and use a spray bottle with good hot water and a plastic type of brush, and spray it as you brush down in the direction of the fins on the coil. The water should drain away to the out side drain holes or hose which ever you may have. Make sure you have a filter there to prevent this from getting dirty. If you don't have one, you can buy a small roll of foam type filter material and cut a piece to fit. Please don't forget to rate me on this as I know you will be kind. I will check back in on you to see how it is going as I keep you and all others on file for future use, and you can contact me also.
Sincerely,
Shastalaker7
A/C, & Heating Contractor

Amana AAC051FRB... | Answered on Sep 10, 2010


These are hermetically sealed units and you are unable to recharge them without using a piercing valve. If you are able to do this they normally take r-22 freon, but you need to be EPA certified to purchase it.

Amana AAC051FRB... | Answered on Jun 23, 2009


the board or the heater need to be replaced

Amana AAC051FRB... | Answered on Jan 06, 2009


WHAT DID YOU DO TO IT?

Amana AAC051FRB... | Answered on Jan 06, 2009


you should probebly have a technician ;look at your unit . if its a heat pump the reversing valve may not be owrking correctly. Also if it is not a hp then the electric heaters may have a bad sequencer and or limit that is not operating properly. Either way the quickest way to get it up and runing would be to call a technician out to repair it. Have a Merry Christmas!

Amana AAC051FRB... | Answered on Dec 23, 2008


is it a heat pump or straight electric heat??

Amana AAC051FRB... | Answered on Sep 30, 2007


There should be a fan symbol on your remote control. In the "mode" control, there should be the following options.. Heat, cool, Auto and fan. If you select fan, only the fan will run. No heating or cooling.

Amana Heating &... | Answered on Jun 10, 2019


Check voltage in , there could be one side of breaker burned causing only one side to come through. This happens on older main breakers frequently which messes up whole house.

Amana Heating &... | Answered on Jun 10, 2019


How are you determining that one section.is cold and one warm? If this is in fact the case you have a blockage in the coil or a compressor that is down provided this is a multi compressor unit.

Amana Heating &... | Answered on Feb 06, 2019


I'm leaning 2 directions, one is that your tstat is sensing your heatpump can not keep up with the load. Therefore bringing on heat strips or two, you have a cycles per hour limit set for compressor heating and your machine is cycling too often.

Amana Heating &... | Answered on Jan 27, 2019


F1 - Control Board Failure - Replace control board (ERC). F2 - Oven Temperature Too Hot - Replace oven temperature sensor. F3 / F4 - Shorted or Open OvenTemperature Sensor - Replace oven temperature sensor. F5 / F6 / F8 - Control Board Failure - Replace control board.

Amana Heating &... | Answered on Jan 20, 2019

Not finding what you are looking for?
Amana AAC051FRB Air Conditioner Logo

12 questions posted

Ask a Question

Usually answered in minutes!

Top Amana Heating & Cooling Experts

Donni Steen

Level 3 Expert

687 Answers

Bill Long

Level 3 Expert

606 Answers

WatsHVAC

Level 1 Expert

35 Answers

Are you an Amana Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Amana Heating & Cooling

  • Amana Heating & Cooling

Most Popular Question

eveaperator clogged unclogg

  • Heating & Cooling
Loading...