http://www.fixya.com/support/p518563-honeywell_hz_325_kaz_ceramic_compactSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 24 Dec 2009 08:00:43 GMT80http://www.fixya.com/support/t363913-honeywell_compact_quick_heat_ceramicMy office space heater will turn on for about 5-20 seconds and then it turns off. It will not turn on again for a while and if it does it only stays on for another couple of seconds - any suggestions on fixing this? It's electric and the light always...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t243434-cadet_heater_quite_workingI've got a Cadet C122 wall heater that quite working. There's 240V to the heater and continuity across the reset switch. No continuity across a round metal device that's at the top of the heater above the coils. Is this normal or is this a shutoff...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t276539-dimplex_model_3087sHi, I would appear to havve mislaid the manual for the above heater. Unfortunately I've tried to reset the heater but I can't seem to be able to get the heater to remain on. Can you please help or direct me to a department where I can obtain another...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t304099-fake_smssites from where we can send fake smsThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t320379-floor_furnacei got it lit, but i can't get it to kick on....it is a ward heater company 40sdr....also, what is the stick adjustment thingy next to the one marked pilot......i can read the one marked "pilot" but the other one is illegible....it has markings for on...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t324924-wont_stay_lit_after_20_min_bloweri have a procom 3panel natural gas heater serial #3351383-- model mn 180hpa w/manual blower pf06-yjlf. when in operation and the blower on it will run great for 20 to 25 mins and then shut down includeing the pilot light-- if i burn it without the...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t335529-storage_heaterOur Creda Night Storage Heater has just stopped working. We have changed the fuse in the socket but it still does not work. Could it be the element. Is there any way of finding out whether the element has gone before purchasing a new one.Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t342274-dont_want_cold_cuz_iam_already_therive got a central air and heater on roof if u turn to on fan kicks on and off whith control but no hot air will come out just that cold air that i dont want to feel cuz iam alredy cold thats y i wanted the heat system tio work pleas gve idea also...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t347594-sterling_mobility_scooter_diplomat_408trying to get user and electrical wireing diagramThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t348834-procom_ventfree_natural_gas_30_000btuI wood like to change heater to Propane .I am looking for a kitThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t360204-troubleshooting_techniques_natural_gaswhere can I get info regarding troubleshooting techniques for natural gas spark ignition modules.Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t366934-heater_not_working_rightmy desa ventless heater is putting out a very bad odor and is putting a very bad smokey film on anything around it. The heater is about 2 yrs. old.Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t371899-electric_baseboard_thermostat_wiringI am replacing the thermostat for my 2 electric baseboard heaters and the replacement unit I bought has 4 wires, red, white, green and black while the old uint had just red and black. There are 3 white wires, 3 black wires and bare solid copper. I...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t376804-space_heaterOne of the 2 quartz elements had burnt out. Is there a replacement available.??Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t379839-lowes_item_number_140389My 40 gal hot water heater wil not work the water wont get hot we just installed itThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t398534-reedy_heater_110_proheater runs a few min,s then it shut,s off . what is the answerThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t403094-identifying_electronic_componentI have a component that looks like a resistor but only haves two colour bands could you suggest what it may be it is on the circuit board of an incubatorThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t388604-mattress_pad_1_2_not_heating_k85kqpOnly 1/2 of the pad is working. I did check all connections and all are good. I have an Induction tester for ac power this showed power on 1/2 of the pad and NO POWER on the other half. In fact this tester will find an open circuit but no such thing,...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t434334-holmes_tower_quartzthe wire from the off- low - high switch to the top of the element burned into. there are 2 small diode looking parts spliced into the wire this is where the problem happened. what are these? do i need them? if so where can i get them? thanksThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t445304-heater_wont_igniteHeater goes through it cycle but ignitor wont glow. Replaced ignitor/pilot assembly.no effect. pulled plug on ignitor and tested for power to ignitor on gas valve pins. I can get 25 volts on one pin if I test to ground. If I test to the two pins I...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t603304-portable_radiant_convector_heater_burnerhi there i have an everdure bridadier 25mj portable gas heater. 2 of my 7 burners are not working properly. they do seem to have a flame behind them but they are not burning as brightly as the other burners. how can i fix this problem? does anyone...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t613114-1000_000_btu_reddy_heaterNeed a wiring diagram for old heater 1984 I thinkThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t849899-cannot_start_brivis_heating_deviceThe screen on the wall has several buttons incl "fan" at the top and three at bottom..Auto, Mode and Prog. "Fan" starts the actual fan but with no heat emerging. Pressing the others makes no difference except "Prog" shows days ?and time etc.Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1077204-natural_gas_patio_heaterPilot flame is coming on, however, once I release the pilot knob and try to turn knob to low or high the flame goes out immediately.. I took the top off and nothing appears to be clogged... Any suggestion?Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1097669-creda_economy_7_heaters_not_workingLast year they worked perfectly. Tried to turn them on this year, have kept the same settings as last year and set it up exactly the same way, but the heaters dont seem to be working. No clothes have ever been put over them. Seems like the 'message'...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1162399-install_aquastat_relay_l8148j1009I would like to know how to install aquastat relay L8148j1009 step by step pls thnksThu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1184189-home_heating_system_questionMy heater had it's twice yearly service about a month ago and everything checked out. I used the heat for the first time a few days ago and it made a loud noise (like a lawn mower). I called the service company and the technician said that the...Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1210389-comfort_zone_infrared_heaterHeater thermostat temp. does not match wall thermostat temp.Thu, 24 Dec 2009 08:00:43 GMThttp://www.fixya.com/support/t1241604-need_help_hooking_right_colored_prongcan you guys please help me?? i had a sequencer to go bad on my electric furnace so i drew up a diagram of the what wires went to what prongs, bought the piece came back to hook it up and what happens i cant find my diagram anywhere now i am stuck...Thu, 24 Dec 2009 08:00:43 GMT