http://www.fixya.com/support/p518462-bosch_nexxt_700_series_wfmc6401uc_frontSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 07 Jan 2010 11:51:57 GMT80http://www.fixya.com/support/t3512749-get_bosch_nexxt_700_series_washerI can't get my Bosch Nexxt 700 Series washer to stay level even after building a small level platform and adjusting leveling legsThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t3258361-bosch_nexxt_700_drain_waterBosch Nexxt 700 won't drain water after washing cycle. Switched to Spin mode, only hear humming noise. Drainage pipe is clear.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t3452000-hearing_scratching_sound_while_drumhearing a scratching sound while drum is spinning...sounds like something is scraping it?Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t3356213-wont_unlock_after_giving_me_f04_codeit wont unlock after giving me the f04 code... cause it has water in it but i need to open it! it also the drum wont spinThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t3243438-rubber_seal_front_machineThe rubber seal at the front of the machine has gone mouldy. I have cleaned it before with bleach but the mould comes back all the timeThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t3224091-bosch_nexxt_700_series_wfmc6401uc_frontBosch Nexxt 700 Series WFMC6401UC Front Load,wont spin at times water lays in bottom and all cloths are wet. There is a 800 and 1200 rpm cycles and both do the same,Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t2675166-only_hot_water_going_into_machine_allI bought my machine 2 months ago & its been like that since I bought it. I turned off both hot & cold water at the tap & turned the cold back on & you can hear the machine but no water. Took off the hoses & checked to make sure...Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t2755556-wash_cycle_starts_5_second_deliveryThe machine is a Bosch Classixx 1400 Express. The cycle starts then there is no activity whilst the time remaining clock counts down.The soap tablets remain dry so I took the drawer out to observe what happens at the cycle start and there is a 5...Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t2109910-bosch_washing_machine_not_drawing_waterMy Bosch front loader washing machine does not draw water. I "thought" I was washing my clothes and when I went to put them in the dryer, shocker!, my clothes were still dry! So I started up the load again and water is not coming into the washer at...Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t2020463-hard_scratchy_towels_used_all_washBosch WAE 20261 au. Front loading Washing Machine. Towels hard and scratchy. I have tried all the different cycles, use minimal detergent and add fabric softener.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t1960027-door_not_unlockmy washing machine door does not unlock instead it makes an strange noise..Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t1527420-get_cabinet_back_base_sears_series_70I just replaced the water valve and now I can't get the cabinet to sit on the base correctly. Does the side flanges of the cabinet fit behind the back panel or inside?Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t341708-not_drainingi have a bosch nexxt 700 series front load washer and the water is draing very slow.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t194539-kenmore_elite_he3_front_loading_washerI have had alot of trouble with this washing machine. I have had it for a 1&1/2 years. First the rubber around the door went out and now on of one of the plastic things connected to the steel drums broke off. It is suppose to be such a great washer...Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t196807-front_panel_removalOpen door button is tuck. We are trying to remove the front control panel for access so we can un stick the buttonThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t199347-miele_washing_machine_model_w713_front15 years old - no previous maintenance done Filters maintained clean. Problem: 1) machine leaks water underneath after completing wash & rinse cycle 2) always washes a very long time ( approx. 3 hours to complete) regardless of pressing short...Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t199171-drain_pump_replacement_instructionI have a top mount Roper washer that's leaking from the Drain Pump (It's the only thing that's wet when i looked in the bottom). Is it possible to get a step by step instruction on replacing the pump?Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t205159-kenmore_washerI just can't figure this one out My Washer will fill up then it will wash for about 12 seconds and shut off, we have replaced the timmer. Can you help us. Kenmore Model # 110 92581200 Serial # CD 3229543Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t208779-kenmore_washing_machinemy machine will not spin the timmer stops when it reaches the spin cycleThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t209335-whirlpool_washer_awm5100ACQUIRED ABOVE WASHER. UNACCOMPANIED BY INSTRUCTIONS MANUAL. PLEASE ADVISE HOW TO USE THIS MACHINE. THANKS.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t210235-whirlpool_top_load_washing_machineThe agitator won't move during the washing cycle and the it will not dispense the softener. When the machine is off you can spin the agitator freely with your hand.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t213099-kenmore_washer_drain_pump_not_comingFills fine, agitates, gets to drain cycle and nothing happens- no noise from the pump- more common pump problem or timer problem?Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t213323-final_spin_cycle_kenmore_417_40042990My washer will not do the final spin cycle in any mode of wash, regular,perm press,etc. until I move the timer back to the begining of the final spin cycle after the initail cycle is over.The motor and timer have been changed.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t213531-hoover_premier_10_1_kg_washing_machineOn the spin cycle the motor rotates, water is pumped out but the drum is not spinningThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t223267-hot_cold_water_knob_will_not_workI have a Kenmore 90 Series washer Model number 20922991. The knobs for all the different water temps. work such as Warm/Cold, Cold/Cold, etc. When I turn the knob to Hot/Cold no water comes out. Please advise. Thank you.Thu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t223531-kenmore_series_70_washer_model_110Washer fills, but will not spin.? No motor noise at spin cycle.? Did a large load break it?? The wash bin appears to be loose.? There is nothing for the pokey piece in the lid to press to activate the spin cylcleThu, 07 Jan 2010 11:51:57 GMThttp://www.fixya.com/support/t224347-spots_white_clothesHI, MY CLOTHES HAVE BROWN SPOTS, LIKE TAR/GREASE, AND THE SAME APPEAR ON THE AGITATOR. SIMILAR DRIPS RUN UNDERNEATH THE AGITATOR BASE. THANKS A LOT, BARBThu, 07 Jan 2010 11:51:57 GMT