20 Most Recent
Magnum DeltaForce CB Radio Questions & Answers
Cb mic wiring
I have a browning golden eagle mark II. It has a two pin mic plug. I would like to hook up a astatic power mic to it. Anyone have an answer?
9/20/2019 11:59:01 PM •
Magnum...
•
Answered
on Sep 20, 2019
How fix talkback in magnum delta force
you need to check the audio path from the chatback board to the audio circuit
usually the audio out the board will go to the center connection
on the volume control
sometimes people use a resistor to attenumate it to a level
or a T pad
and connect it to the left side {audio out to amp}
so a volume control works like this
left center right
ground audio into control audio to amp
so usually the center is used as the volume will track up as your sets volume is increased
so simply connect the audio out from the chatback
to the right audio to amp section
on the chatbacks ive made and installed in the past
had a small pot on the board
this allows the volume from it too be increased
so look for this first
if you cant find it you can make one up like this
100K log pot 3 pin
1 2 3
L M R {left middle right}
1= ground
2= audio from chatback
3= audio to the right right audio to amp on the cb's volume control
then no matter what level the actual audio from the set is set too
the chatback can be set to a standard level for all
hope this helps you
i used too build chatbacks for the rnid year back and fit them free
12/2/2014 12:42:23 PM •
Magnum...
•
Answered
on Dec 02, 2014
Channel selector only works going down not up
there is two common connections to the channel selector
up and down
resolder the channel sectors pins
then it will work
its a broken connection to a common pin
if its not a break on the selector to the PLL data bus then
use DE-OXITE 50 {this one no others for selectors} look on ebay for it
11/30/2014 5:44:49 PM •
Magnum...
•
Answered
on Nov 30, 2014
Wire 4 pin microphone
Here is how it should be wired. --- Pin 1 -> Shield --- Pin 2 -> Modulation --- Pin 3 --> Transmit Switch --- Pin 4 --> Receive
PiP
2/3/2014 7:12:48 PM •
Magnum...
•
Answered
on Feb 03, 2014
How do i wire a d104 desk mic to a madison base
You don't mention if the Madison is a 4 pin or 5 pin also you don't mention if the D104 is a 4 wire or a 6 wire microphone so this will be rather lengthly of an answer so if I help you could you atleast do the rating for me ? So here goes 4 pin / 4 wire 1]SHIELD 2] WHITE 3] RED 4] BLACK....O.K. 4 pin 6 wire 1]SHIELD & BLUE 2] WHITE 3] RED 4] BLACK YELLOW NO CONNECTION.....Are you with me so far ? Half over 5 pin 4 wire 1] WHITE 2]SHIELD 3] BLACK 4]N/C 5] RED.....5 pin 6 wire 1] WHITE 2] SHIELD&BLUE 3] BLACK 4]N/C 5] RED.I hope this helps you GOOD LUCK and have a good day Dan.
1/25/2014 1:26:44 AM •
Magnum...
•
Answered
on Jan 25, 2014
Not finding what you are looking for?