20 Most Recent Danby DMW112 Microwave Oven Questions & Answers

No. The unit is only supposed to pull 9.1 amps. (wattage divided by voltage equals amps) Your unit has a short, or your breaker is bad. Turn on the unit, when it trips the breaker see if the breaker is hot, If so, thats an indication the breaker is bad.

If your appliance has absolutely no functions at all, remove it from the mains supply, remove the case and see where the mains lead goes in to the appliance and follow the cable until you find the main fuse.
ONLY USE THE SAME TYPE AND RATING OF FUSE TO REPLACE IT.
The usual cause of this fuse failure is the door switches are contaminated or sticking. Check the door switches before putting power back on to the appliance.
Hope this helps.

i have power and light is on can not press any numbers or start button or any other button.it keeps on peeping steady

hello. push the clock button and then put in the time using the number keys, THEN push the clock button a SECOND TIME to make it work.

IF the noise is a sound coming from the oven area, its the megatron tube. Typically, replacing the megatron tube is more expensive than replacing wiht a new unit and a new warranty.

Danby Product Registration

If it keeps blowing a fuse then there is something that is causing the current spike blowing the fuse. I would run a full diagnostic or ask a qualified electrician. Something else is most likely blown and replacing a fuse would probably just feed the problem.

http://www.danby.com/fr/soutien/#achat-de-garantie-prolongee Call to request. French and English web site.

Weird that it worked when you left then not. Have you had the lights inside of your house dimming off and on?? It could mean a bad neutral connection to your house from the power pole. That can cause the low voltage transformer on the timer board to burn out. So the fuse in the unit will not even blow but still kill the Low Voltage transformer. If sounds possible call your power company to do a "load test" on the incoming power lines to your house.. They don't typically even charge to do that. They take out your meter and put a tester in that spot that tests the supply to your house.

When talking about "Power Level", there is a misconception that the cooking power is being adjusted. This is not the case. The user is actually adjusting the duty cycle of the Magnetron. For instance at 30%, the Magnetron will be turned on for 20 sec. and off for 40 sec. A loud 60 cycle hum is usually caused by a shorted Magnetron. Thus the unit is not economically repairable.

the to register --warranty details and equipment serial number will be on the warranty card that came with the equipment follow those instructions or google the manufacturers site click on the " contact us" tab , fill out the details and in the comment box type in the equipment details , date of purchase , serial number , model etc and request that it be registered in the company warranty records

thats a fridge try fiddling with the temp control low to high if compressor motor wont kick in might be low on refrigerant ..re gas

well im not a doctor , but I do know about metals a lot . rust is oxidized steel , that at least a good part of it is the mineral iron, now ive heard that your blood needs iron daily to keep healthy , its just I do not believe that the rust enhances the taste of your food