Gateway 7330GZ Notebook - Answered Questions & Fixed issues


Ensure the correct switch assembly is used as they are different heights for different models.

Gateway 7330GZ... | Answered on Mar 05, 2018 | 181 views


Hi! this is Alex Walker expert to help you for this issue call me on +1(518)348-9393 I will be glad to assist you Thank

Gateway 7330GZ... | Answered on Aug 22, 2017 | 85 views


Remove the battery and run off of the A/C power adapter without the battery installed.

If it works, the battery is just discharged too much. After Windows settles, insert the battery and let it charge.


Gateway 7330GZ... | Answered on Oct 24, 2015 | 394 views


The dreaded loose video chip. pay $100 and have a professional fix it for you. There are several listed on-line that take them apart and will heat the solder joints back up to fix it.

Gateway 7330GZ... | Answered on Apr 29, 2015 | 28 views


Hi,
Take a look on this webpage: Driver Update Tool for driver related problems. Wish you best of luck
Dave

Gateway 7330GZ... | Answered on Jan 05, 2015 | 990 views


Without that HD password, you are out of luck. Only thing you can do is install a new hard drive, and reload everything. You cannot even retreive any data you have on a passworded hard drive without the password.

Gateway 7330GZ... | Answered on Jan 01, 2015 | 501 views


This probably isn't a driver problem. Your backlight power cable is probably loose. You can tell by getting a flashlight and looking closely at your monitor while it's powered on. If you can see your desktop items then it's a backlight cable problem. I had the same problem with my Gateway. You can remove the front bezel from your display to get to the cable. I just pressed mine up into the display as much as possible and put a little hot glue on it to keep it from backing out. I never had the flickering problem again. Good luck.

Gateway 7330GZ... | Answered on Apr 10, 2014 | 26 views


There are 2 set of cable that run from the display to the monitor, be very careful with it. In most cases, to remove these cables you need to disassemble the whole laptop. Now, since you are on Y changing the hinges, I think you can do it, just don't pull on the monitor too hard, and it needs to be place on a flat surface very close to the laptop. It's not that hard, you just need to be careful, that's all.

Gateway 7330GZ... | Answered on Jun 20, 2013 | 44 views


You would have to take apart the top-case of your laptop(the plastic encasing the LCD). Behind the LCD there is a cable that plugs into it that goes down to the motherboard. Reseat that cable and test again to see if that fixed the issue. It is actually quite a common issue in my line of work as an IT consultant.

Gateway 7330GZ... | Answered on Apr 29, 2015 | 42 views


You most likely have a loose video connects. Try re-seating the video connectors.

Gateway 7330GZ... | Answered on Feb 10, 2013 | 27 views


To connect your computer to a wireless router, you click the Refresh network list, then Choose your wireless network and then click Connect to your secured Wireless Network, it will asks for a Network Key before allowing you to connect into your wireless network. This Network Key is either the WEP, or WPA or WPA2 Encryption key that is used to configure the Wireless Router. The Passphrase is an alternate way to setup the Encryption key.
When you are requested for a Network Key, you can just enter the Passphrase that was used to configure the Encryption key in the wireless router. http://www.fixya.com/support/r5270415-network_password_network_address For information on securing your wireless network, configuring the wireless router and configuring the wireless card in the laptop/computer, please click on this link and follow my instructions :- http://www.fixya.com/support/r3559128-wireless_router_security

Gateway 7330GZ... | Answered on Sep 30, 2012 | 85 views


Return the laptop to the place of purchase, this is a manufacture issue.

Gateway 7330GZ... | Answered on Jun 20, 2012 | 89 views


Does it look like it started and booted up ok except the screen is blank? If so try the steps below.

Shine a flashlight on the dark screen to see if you barely see the icons on the desktop. If so, then the LCD Inverter is bad.

Plug in an external monitor and see if the display shows up on it. It can be any kind of monitor even the old big fat crt monitors as long as it has a vga cable to connect to your computer's vga port. If so that proves your video card is ok. The video will show on most systems when you reboot without you having to do anything. Some systems will require you to hit the FN (Function key) + F1 thru F12. Hold down the FN key then hit the correct key for displaying on the monitor (F1 thru F12). The correct key will normally have CRT/LCD on it or it will have the icon of a display.

If you see no icons by shinning a flash light and the external monitor works, then your screen is bad. If you see no icons by shinning the flash light and nothing shows on the external monitor, then most likely your video card is bad.
If it does not seem like it started up ok, then try the steps below.

When you plug in the power cord is there any lights whatsoever on the laptop, where the plug goes in or on the AC Adapter of the power cord?

When you press the power button do you hear fans running, hard drive spinning, lights on the computer, hear any beeps or lights constantly blinking, hear the DvD/CD drive click and the light on the drawer of the DvD/CD turn on for a second or two? If so the laptop is trying to boot or may have booted, but the screen is not showing for some reason.

Beep tones and blinking lights tells the technicians what is going on with the laptop and why it is not booting. Most times it's a motherboard issue when you hear beeps or blinking lights continuous. Most times the problem is with the memory or Video Card. Count the Blinking Lights or Beeps and take note of their pattern (1 Long or 1 Long followed by 2 Short).

Maybe your power cord is bad if you don't get anything to happen whatsoever when you press the power button. And if that's true maybe you was operating off the battery the last time you had it on and since the power cord is bad, it was not charging the battery so the battery is drained and the power cord is bad.

Maybe you have a Static Charge Buildup. Remove the Power Cord, Remove the Battery, then Press and Hold the power button for 30 seconds. After 30 seconds plug the power cord back in (leave the battery out) and hit the power button to see if it boots. If it does, you can put the battery back in and let it charge.


Maybe your DC Power Jack which is where the power cord plugs into the computer is bad. Take an ink pen and push the tip inside the jack and see if the little pin wiggles, if so the jack is bad. You'll have to take the laptop apart to fix it. Most times it is soldered onto the motherboard, so you will have to desolder the old and solder a new one.


Maybe your memory is bad or the memory slot is bad.

Remove the Power Cord, Open the Case and remove one of the memory chips. Set the chip aside then try rebooting the computer. If it boots, then you know the memory chip you set aside is bad so mark an x on it with an ink pen. If it fails to boot then move the chip to the next memory slot and try rebooting. If it fails take the chip out and set it aside, then put the other chip in and try booting it in both slots. If it boots, just to verify that the chip set aside is bad, mark an x on it and put it into the open memory chip slot and try booting.

Gateway 7330GZ... | Answered on May 01, 2012 | 31 views


XP install disk will partition the hdd and format it before installing operating system. great for removing virus etc.

Gateway 7330GZ... | Answered on Apr 18, 2012 | 66 views


So who put the password on it? 99% of the time if there is a Hard Drive Password and the person in possession of the laptop don't know the password, the laptop is stolen. The original owner put the password lock on the hard drive to keep thieves from getting to sensitive data. The owner could have set the password remotely once the laptop was stolen. Your system is toast. The only remedy is to get the original owner to remove the password.

Gateway 7330GZ... | Answered on Apr 11, 2018 | 172 views


Not only does Wi-Fi have to be on, but it has to be connected to a wireless access point (sometimes called a wireless router), and the wireless access point has to be properly connected to the internet.If the wireless access point/router has empty ports on it, plug your computer into one of those ports, and see if you can connect to ther internet then. If you can, the problem is somewhere between the wireless access point/router and the computer. Could be the transmitter part of the wireless router, could be the wireless network adapter on your computer, or could be the driver that runs the wireless adapter on the computer. If you cannot access the internet when you plug into the wireless ap/router, then you need to go one step "upstream." This would likely be the cable modem or DSL modem. Plug directly into that with your computer, and reboot both the modem and the computer (just unplug the power from the modem and then plug it back in to reboot the modem). If you can connect to the internet then, the problem is the wireless router/ap. If you cannot connect to the internet then, contact your ISP.

Gateway 7330GZ... | Answered on Feb 09, 2012 | 203 views


Your computer works fine. Its just a little plastic tab that has broken off of the power button. Bad design! The power button doesn't sit right about the power switch. The broken tab makes the switch. The button is directly about the LED light. You have to remove the power button panel (Your user manual will instruct you on that) and then you can rig something where the plast tab was or just remove the circuit board from the panel and just power it on with your finger on the circuit board. No risk of shock. Well it hasn't gotten me yet :o) There's only two screws that you have to remove from the back of the computer to remove the panel and keep in mind that the top hinge covers are part of the power button panel so you have to gently loosen those with a little screw driver as well.

Gateway 7330GZ... | Answered on Oct 10, 2011 | 350 views


Hi
You need to go to another computer and download and install Microsoft Safety Scanner on a portable hard drive, thumb drive or pen drive, then you will start your computer in the safe mode and then plug in and download, install and run the Microsoft Safety Scanner...
----------------------------------------------------------------------------------------------------------
Or you can....
Start your computer in the "Safe Mode", you do this by tapping F8 while the computer is starting up.
Once you are in the safe mode then go to the webpage below and download and run the microsoft safety scanner, this may take several hours to complete the scan and fix.
If the virus is not removed then you can chat with an expert (for free) and he will (with your permission) take over the computer and remove the virus for you.
Please take time to rate me

http://www.microsoft.com/security/scanner/en-ca/default.aspx

Gateway 7330GZ... | Answered on Aug 16, 2011 | 114 views


Hello,

As you mentioned that you have updated OS, it is possible that the version of installed drivers for the touch pad are not compatible with the new OS.

I suggest you do is you go to the manufacturer's website and download the latest drivers. Most manufacturers offer an online support for the different drivers / software required by the computer.

This link is the direct link to download the latest drivers for your computer:Touchpad Driver

> Click on the link and download the drivers.
> Meanwhile go on Control Panel> Add / Remove Programs and uninstall Synaptics.
> Once the download is complete, launch the newly downloaded driver installation.
> After the installation is complete, restart your computer.

The touch pad should have now recovered all of its features.

Glad to help.

Gateway 7330GZ... | Answered on Jul 03, 2011 | 139 views

Not finding what you are looking for?
Gateway 7330GZ Notebook Logo

Popular Tags

190 questions posted

Ask a Question

Usually answered in minutes!

Top Gateway Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Prashant M
Prashant M

Level 3 Expert

2276 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Are you a Gateway Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...