Dometic CS-200 Wine Cooler - Answered Questions & Fixed issues

bad temp sensor

Dometic CS-200... | Answered on Oct 14, 2017 | 107 views

check temp sensor inside fridge see if it fell into pan

Dometic CS-200... | Answered on Oct 03, 2017 | 150 views

check voltage if too low will mess with control panel

Dometic CS-200... | Answered on Jun 03, 2016 | 60 views

If the back of the refrigerator is getting warm and the refrigerator is level then you more then likely will require a replacement cooling unit. You can visit our online Store or give us a call directly 1-888-782-6665 We ship throughout North America!

Dometic CS-200... | Answered on Sep 24, 2014 | 75 views

make sure motor home is level

Dometic CS-200... | Answered on Jul 27, 2009 | 211 views

If your cooling unit is gurgling, then you have air in the system or a bad cooling unit. There is a process known as "burping" that should help repair this. It is a rather lengthy process and will require two people.

1. Access the rear of the refrigerator. Turn off the LP gas to the unit. Remove the LP Gas line and the 12Volt supply. Unplug the fridge.
2. Remove the screws in the rear at the bottom and then remove the screws from the inside.
3. Pull the fridge out and lay it down on it's right side for 8 hours.
4. Flip the fridge on it's top for 8 hours
5. Now the left side, then back to normal.
6. Reinstall the fridge and turn gas back on.

Hope this helps,


Dometic CS-200... | Answered on Jul 08, 2009 | 939 views

try unplugging thermistor from board let run if gets cold replace if not bad board

Dometic... | Answered on Sep 22, 2018 | 41 views

have it replaced

Dometic... | Answered on Sep 17, 2018 | 51 views

see if voltage to heater element if yes replace element if no check fuse on board

Dometic... | Answered on Sep 15, 2018 | 57 views

check gas pressure and blow out line, possible cob web

Dometic... | Answered on Sep 15, 2018 | 52 views

Contact the manufacturer, Absorption refrigeration is an infrequently used alternative to compression refrigeration. Absorption refrigerators use a solution of ammonia and water as refrigerant fluid. A gas flame heats the ammonia and provides the energy that drives the cooling process. These models are generally very simple and have few moving parts. This is a very straightforward process. There are three main principles behind proper operation of an absorption refrigerator. Place the refrigerator on a level surface. Make sure that it is adequately ventilated. Check that the correct heat is being applied in the boiler. As long as there are no leaks, this should be enough for the refrigerator to work properly.

Dometic... | Answered on Sep 03, 2018 | 66 views

if you ran 220 volts through you welded switch check all other wiring

Dometic... | Answered on Sep 03, 2018 | 32 views

sounds like arms were hit or wind moved fabric open up remove screws on top rail slide fabric so arms in line then close if arms ok re set screw in track

Dometic... | Answered on Aug 25, 2018 | 44 views

hooked up to control board and fished into fridge comes out on back wall

Dometic... | Answered on Aug 25, 2018 | 45 views

try checking fusible links if ok try with thermistor unplugged if ok replace

Dometic... | Answered on Aug 12, 2018 | 505 views

Not finding what you are looking for?
Dometic CS-200 Wine Cooler Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Dometic Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Charles T Nevin
Charles T Nevin

Level 3 Expert

4070 Answers

Lollo Pop

Level 2 Expert

115 Answers

Are you a Dometic Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides