http://www.fixya.com/support/p479748-ge_24_in_gld5500l_built_in_dishwasherSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comFri, 22 Aug 2008 00:54:37 GMT80http://www.fixya.com/support/t206125-dirty_dishwasherMy dishes are coming out clean enough, but my dishwasher door stay s dirty with the drippings from the dirty dishes. How is that possible? also,I can see gook underneath the mesh on bottom. How do I get that mesh out to clean it?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t206544-dishwasherwater is not coming in my dishwasher and how do i dismantle the spray arm at the bottom to cleanFri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t201574-door_switch_whirlpool_dishwasherTHE DOOR ON MY DISHWASHER DOES NOT SEEM TO B BE CLOSING QUITE RIGHT. tHE PUSH BUTTONS ON THE FRONT WILL NOT WORK. cOULD THERE BE A CONNECTION?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t202454-frigidaire_dishwasher_leakingMy dishwasher started leaking from the left corner of door, now it's pouring out of the center of the door as well as the left corner. I have replaced the seal and fixed an existing problem that I didn't know I had with the water line. Where it...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t202759-dishwasher_dishes_not_cleanDear Mr/Ms, We have a kenmore elite stanless steel dishwasher. It is around 5yr old it is not getting all of the dishes clean, some time leaving water with debree on the water left on the bottem of glasses/cups. We had this problem before and I now...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t203604-lg_dishwasherMy LG Dishwasher Model: LD 14AW2 Electronic stand alone keeps on coming up with an error E1? I am not sure what it is because we have no instruction manual. The dishwasher is about 2 1/2 years old. I am doing a standard (Normal) wash. It starts to...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t193459-dishwasher_not_pumping_waterHi, My dishwasher is not pumping water through the rotating arms. I have been noticing that the dishes were coming out dirty and the detergent tablet falls to the bottom of the machine. I have put the machine on just a rinse cycle. (someone told me...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t197349-dishwasher_wont_fill_waterMY DISHWASHER WILL NOT FILL WITH WATER, I HAVE CHECKED FOR ANY BLOCKS AND ALL SEEMS FINE, I HAVE JUST LOOKED UNDER IT AND FOUND A SMALL LEEK IN THE WASTE PIPE JUST AS IT LEAVES THE MACHINE BUT WHEN I FILLED IT MANUALLY IN DRAINED OK COULD THIS BE MY...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t197474-dishwasher_repairDishwasher is a Stoves/Newhome DW616 Rotating spray arms do not always operate. This is an intermittent problem - will sometimes work normally for a few days then arms will not move at all with no water coming from them. Machine appears to go...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t199059-dishwasher_not_cleaningOver the past 2 weeks, my cups have a sand like substance in them. I have hand washed every item before loading and even changed brand of dishwashing detergent. I then took out the screen in the bottom and cleaning it. It is still...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t199129-pe_error_message_lg_dishwasher_ldThe error message of "PE" comes on the screen when I try to run a cycle. If I open and close the door and try it a couple of times the error message finally goes away and you can start the cycle. Occasionally the cycle would stop with the "PE"...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t13684-dishwasher_not_clean_dishes_properlyI have a dishwasher that does not clean the dishes properly. It leaves stuff that looks almost like sand on the top of all the dishes on the top rack. I have tried everything I can think of. can someone help me figure this one out?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t13689-questionis_prevent_cloudy_glassware_inmy questionis: How to Prevent Cloudy Glassware in the Dishwasher?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t101579-dishwasher_doesnt_washThe dishes I put in my dishwasher don't ome out clean. What could be causing this?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t102579-water_levelWhat should the correct and/or optimum water level be in the tub of this dishwasher for proper operation?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t102664-machine_not_fill_waterOn starting any cycle, following the tablet droping, the nachine does not fill with water. The cycle goes through as nornam without water. Cosequently the dishes do not get washed!Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t102824-water_fill_levelI would like to know how much water should be in the tub with each fill. How can I tell via a measurement, if the dishwasher is filling up with enough water during each fill cycle? Does it need a gallon of water, or a gallon and a half, etc..?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t103039-dishwasher_keeps_runningdishwasher fills with water then starts its cycle but it does not progress any further,it just continues runing until you switch it off or open the door,where upon opening the door you find the contents covered in almost bubly water.Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t103919-continuous_rinsingMy son used a large quantity of washing up liquid instead of dishwasher powder and now the machine will not stop rinsing and is still full of bubbles. What can I use to nutrelise the soap and stop the rinsing?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t114489-not_enough_waterI've changed the water lines, cleaned the fill valve and find nothing. I replaced the timer, and still very little water in tub! Checked the float, looks good. This model seems to fill by timer not float. It works great when I manually add water. Any...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t131574-figidare_dishwasherUpper arm not rotating, no water coming from top hole to fill upper arm.Lower arm rotates shoot water up cleaned filter screens. Check ball seems ok by pump, is there a location it (ck ball) should be?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t208194-kenmore_dishwasherWhen I push start on my dishwasher it does nothing. The lights work on the wash settings and the dry settings but when I push the start button, nothing.Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t218719-beko_dishwasherthe water will not heat up in my dishwasher.Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t220209-dishwasher_problemhi there I have a fault with the dishwasher. when i try and switch it onto wash, it produces a loud beeping, and all lights apart from the last 2 flash. i dont want to pay ?70 per hour labour. is it something simple i can fix?Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t222789-ge_trition_dishwasher_leakWhile performing a cycle, the dishwasher leaks out onto the floor. Seems to be coming from between the door seal. It does not happen all the time and does not come fromthe same side all the time. I have cleaned the seal of food particles and it...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t222844-kenmore_ultra_wash_dishwasher_blinkingI have a Kenmore Ultra Wash Quiet Guard 3 dishwasher. The Quick Rinse light keeps blinking, and none of the other buttons work except for the Cancel/Drain button. When you push the Cancel button, the 4 hours light turns on, but it doesn't do...Fri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t225189-asko_1605_cycle_stopped_pump_keepsasko 1605 cycle stopped, pump keeps running, water pumps out but will not progress to the rinse and wash cycles. Timmer will turn and detergen dispenser will open. Pump keeps runningFri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t226694-require_switch_dishwasherI require the 7 progam selector switch for Kitchenaid model KDS2o Part # PS 1442462. Please advise where I can obtain it ThanksFri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t235764-dish_washerWhen i turn on the dishwasher as soon as it cycles i have water coming out of the air vent on top of the sink. it is connected to thegarbage disposalFri, 22 Aug 2008 00:54:37 GMThttp://www.fixya.com/support/t241109-water_levelWhat should the correct and/or optimum water level be in the tub of this dishwasher for proper operation? There is water in the bottom of the dishwasher after the cycle completes. 1)checked the hose, it is not kinked 2) not hooked up to a waste...Fri, 22 Aug 2008 00:54:37 GMT