20 Most Recent
Maytag MDE9700AYW Neptune 174 Electric Dryer - Page 2 Questions & Answers
Help with dryer repair???
The first thing to do is unplug it and take the bottom kick panel off. You will see a lot of lint. Get a vacuum cleaner and clean it out. Then you need to look for the heater box. It comes loose with a couple of screws and you can pull it out. Take a picture of it or write down the wire locations. Take the two wires off that go back into the machine. Then you can take it down and have it tested at an appliance shop.
7/7/2014 10:49:54 PM •
Maytag...
•
Answered
on Jul 07, 2014
Same problem
We just discovered the same problem. The drum is cracked at the seam in the very front of the drum. We are going to call tomorrow because I agree, this seems like a manufacturing defect to me. I'll post the outcome after we talk with Maytag.
5/13/2014 2:03:33 AM •
Maytag...
•
Answered
on May 13, 2014
How do you replace the
I am about to find out! But according to Tim Mereno, which by the way sells the part for 65. said it is not really to difficult! I will let you know.
5/4/2014 8:48:59 PM •
Maytag...
•
Answered
on May 04, 2014
No power to the display, dryer will not turn on
First thing you need to do is check the Circuit Breaker for the dryer. If it is tripped unplug the dryer and reset the Circuit Breaker. Now plug in the dryer and try to run it. If it does not work again check the Circuit Breaker again if it is tripped again unplug dryer and call someone that can help you or fix it. If the Circuit Breaker is not tripped check for good power readings on both power lines coming into the dryer. Should have 110V or more on each line to neutral, and 220V or more between each line. If you do not have the correct voltage at each line check Circuit Breaker for good power coming out.
3/15/2014 3:37:13 PM •
Maytag...
•
Answered
on Mar 15, 2014
Dryer thumps on every rotation
Inspect the weld seam in the drum. Mine split in the front leaving a small hole. The thumping is the drum wheels running over the broken seam.
2/10/2014 4:44:55 PM •
Maytag...
•
Answered
on Feb 10, 2014
Maytag neptune error code
anytime a fuse trips it is due to too much load on a circuit-or over heating-tear down the machine and clean out lint look for it in the ducts that exhausts out of the house and even the outside flap-cheers Denny
10/23/2013 2:38:33 AM •
Maytag...
•
Answered
on Oct 23, 2013
Not finding what you are looking for?