20 Most Recent Intel D865PERL Motherboard Questions & Answers


RE-WIRE ALL ELECTRICS CABLE BY THE MANUAL.

Intel D865PERL... | Answered on May 26, 2015


http://support.intel.com/support/motherboards/desktop/d865perl/sb/CS-008962.htm

here is your owneres manual for your motherboard to assist you on where plugs go

Intel D865PERL... | Answered on May 01, 2014


Desktop or Laptop Computer

Test all power and data leads that attach to your hard drive IDE,SATA

the leads from your (motherboard to your hard drive) make sure they have secure dust free connections and are not faulty or just replace them they might be faulty


if its a 40 pin flat ribbon type it will be the first to fail


make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty


even something as small as a faulty electrical fan and its lead can cause you problems

computers need all power and data to continue through every working device and to have an end so any faulty leads will end up with a computer error


make sure your graphics card is securely seated with no dust built up or in the socket

if you remove your graphics check the socket to make sure its dust free


restart your computer then reinstall it this should activate found new hardware wizard


If the computer has run out of charge or is in hibernation or sleep mode,

if the screen is too dark, or if the display cable has come disconnected from the motherboard, the screen may appear black or fail to turn on.

To fix a blacked-out laptop screen, troubleshoot the screen settings, check the LCD connector and see if the computer is awake and receiving power.


hope this helps

Intel D865PERL... | Answered on Sep 09, 2012


click start control panel on the left select hardware and sound then select manage audio devices then recording you should see a microphone right click select enable windows 7


click start control panel on the left select hardware and sound then select manage audio devices then recording you should see a microphone right click select configure speech recognition then

you will see earphones with a speaker among a list set up a microphone headset with microphone then next and next again you should see your earphones with microphone being configured


click start control panel sounds and audio devices select advanced there might be a tick in the mute box untick it or select audio from the microphone drop down list

make sure you have the right one selected and in the volume box make sure the microphone box has a tick in it or
select the voice tab

make sure that you have the right media selected also
select volume make sure the box for microphone has a tick in it

hope this helps

Intel D865PERL... | Answered on Jul 27, 2012


Sounds like your memory or video card is the issue. I would try the memory.

Maybe your memory is bad or the memory slot is bad.

Remove the Power Cord, Open the Case and remove one of the memory chips. Set the chip aside then try rebooting the computer. If it boots, then you know the memory chip you set aside is bad so mark an x on it with an ink pen. If it fails to boot then move the chip to the next memory slot and try rebooting. If it fails take the chip out and set it aside, then put the other chip in and try booting it in both slots. If it boots, just to verify that the chip set aside is bad, mark an x on it and put it into the open memory chip slot and try booting.

Intel D865PERL... | Answered on Jun 01, 2012


More than likely it's the memory or video card that is causing the beeps.

When you plug in the power cord is there any lights whatsoever on the laptop, where the plug goes in or on the AC Adapter of the power cord?

When you press the power button do you hear fans running, hard drive spinning, lights on the computer, hear any beeps or lights constantly blinking, hear the DvD/CD drive click and the light on the drawer of the DvD/CD turn on for a second or two? If so the laptop is trying to boot or may have booted, but the screen is not showing for some reason.

Beep tones and blinking lights tells the technicians what is going on with the laptop and why it is not booting. Most times it's a motherboard issue when you hear beeps or blinking lights continuous. Most times the problem is with the memory or Video Card. Count the Blinking Lights or Beeps and take note of their pattern (1 Long or 1 Long followed by 2 Short).

Maybe your power cord is bad if you don't get anything to happen whatsoever when you press the power button. And if that's true maybe you was operating off the battery the last time you had it on and since the power cord is bad, it was not charging the battery so the battery is drained and the power cord is bad.

Maybe you have a Static Charge Buildup. Remove the Power Cord, Remove the Battery, then Press and Hold the power button for 30 seconds. After 30 seconds plug the power cord back in (leave the battery out) and hit the power button to see if it boots. If it does, you can put the battery back in and let it charge.


Maybe your DC Power Jack which is where the power cord plugs into the computer is bad. Take an ink pen and push the tip inside the jack and see if the little pin wiggles, if so the jack is bad. You'll have to take the laptop apart to fix it. Most times it is soldered onto the motherboard, so you will have to desolder the old and solder a new one.


Maybe your memory is bad or the memory slot is bad.

Remove the Power Cord, Open the Case and remove one of the memory chips. Set the chip aside then try rebooting the computer. If it boots, then you know the memory chip you set aside is bad so mark an x on it with an ink pen. If it fails to boot then move the chip to the next memory slot and try rebooting. If it fails take the chip out and set it aside, then put the other chip in and try booting it in both slots. If it boots, just to verify that the chip set aside is bad, mark an x on it and put it into the open memory chip slot and try booting.

Intel D865PERL... | Answered on May 30, 2012


first your cd dvd drives
Click start control panel administration tools computer management device manager scroll down cd-dvd rom drives you might see a yellow question /exclamation mark ? ! or a red X right click to update driver

you might have to physically unplug the leads for this cd/dvd restart your computer then plug them back this should activate the found new hardware wizard

if this does not fix the problem it might be a registry problem if you cant see your disk drive in windows explorer
Close all open programs

Click on Start, Run, and type regedit and press Enter
Click on the plus signs (+) next to the following folders

HKEY_LOCAL_MACHINE

SYSTEM

CurrentControlSet

Control

Class

{4D36E965-E325-11CE-BFC1-08002BE10318}

This folder is the DVD/CD-ROM Drive Class Description in the registry. Look for any of the following names in the right hand column.

Upper Filters

Lower Filters

Upper Filters.bak

Lower Filters.bak

If any of the above keys shown in step 4 are listed, right-click on them and choose Delete

After deleting the keys, close the registry editor
Reboot your computer

Open My Computer and check to see if your CD or DVD drives have returned. You may also want to open Device Manager and verify that the yellow exclamation and error code on the CD or DVD drive is gone.


then you should be able to load xp
hope it helps



Intel D865PERL... | Answered on May 12, 2012


It is the small round shiny thing to the left of the RAM slots.

Intel D865PERL... | Answered on Apr 17, 2012


You ccan get drivers from the Intel web site:
http://www.intel.com/support/motherboards/desktop/D865PERL/

Intel D865PERL... | Answered on Feb 29, 2012


Hi,
That looks a hardisk failure.
Set the BiOS to "max. default operation", save upon exit. If you still got the same problem replace the HARDiSK.
Try to replace the hardisk and install your favorite OS.

Hope that helps!

Intel D865PERL... | Answered on Dec 07, 2011


During the boot process you will see on the screen to press a certain key to enter setup
Press and hold that key during the boot up process to enter BIOS you can load failsafe defaults or load optimized defaults ,press escape then press f10 to save to cmos to restart
or
During the boot process tap the f8 button three times this will boot into safe mode where the only things working will be your mouse and keyboard enabling you to attempt to repair your computer
Also you might try
Turn Off the computer, now as soon as you hit the power button, keep on holding "Alt" key & keep on tapping "F10 key,ie: Alt+F10, it will open the recovery console ,select full factory restore and follow on screen instruction. (Note:this will erase all datas on the computer)
hope this helps

Intel D865PERL... | Answered on May 14, 2011

Not finding what you are looking for?
Intel D865PERL Motherboard Logo

82 questions posted

Ask a Question

Usually answered in minutes!

Top Intel Computers & Internet Experts

Tony

Level 3 Expert

2600 Answers

Alun Cox

Level 3 Expert

2668 Answers

David
David

Level 3 Expert

781 Answers

Are you an Intel Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Intel Computers & Internet

  • Intel Computers & Internet

Most Popular Question

front pannel j9e2

  • Computers & Internet
Loading...