20 Most Recent Ricoh Aficio CL3500N Laser Printer - Page 4 Questions & Answers

Hello sir; Pull out transfer belt unit replace belt clean blade. it should take care yor problem.

Verify the OPC drum and the polygon motor scanner glass,something is dirty.

SC 441 - development motor lock.Possible causes:too much load on the drive mechanismdevelopment motor defectivepoor drum motor connector connectioninterface board defective

The SC441 error means one or more of the developer units (PCU) is not rotating. You have to take the PCU out to see which color isn't rotating. One of the doctor (cleaning) blades might be flipped, usually caused by lack of toner in the PCU.Basically, if you just open up the printer, latches and everything, and just make sure the parts are all able to move freely by giving them a bit of a test with your hand, then close the printer up turn it off then back on and it should be working.

Hello sir; you need to set up your system from printer, go to manue ,roll down to system , roll down to auto continue,then press enter ,

Hello,The line in the middle of the page is caused by a damaged or worn fusing assembly in the printer. Here is a link to an article showing this issue on the Laserjet 2100 printer and how to replace the fuser unit. Your printer just needs to have the fuser replaced, it is part number RM1-6405 and is available from Amazonhttp://www.ccl-la.com/blog/index.php/how-to-fix-hp-laserjet-2100-vertical-lines-on-print/

WAIT!!! Don't let Ricoh Steal your money...

You're going to get a little bit dirt with the trick, but there is no need to buy a empty waste toner bottel

Empty the waste toner bottle inside a plastic bag, the dust is kind of azard!!!, when the bottle is empty, clean it from the outside.
Place the bottle in the printer, (This is just for reference only), in the right side of the bottle you're going to see a plastic tag all dirty (You see it?) OK!!, remove the bottle from the printer, and then very carfully remove that plastic tag from the bottle taking care of not ripping it off, now clean the plastic tag, and put it in place again, and now your printer is ready to work!!!!!
Where's the trick?, The printer has a Photo sensor that is "looking" trugh this plastic tag, when the plastic tag is full of toner, the sensor can't get the signal, and then it says that the waste bottle is full..!!!

TONY!!