There are pressure switches (weighs the tub) connect to the tub... towels and sheets hold more water and therefor weigh more.. try washing less pieces and see if that helps..
This is another example of our government knowing whats best for us!! I have to wash two or three more loads.. and THEN rinse and spin each to get them clean.. I use A LOT more water this way...
LG WM2688H Front Load Washer Smoking power ... - Fixya
www.fixya.com > ... > LG > WM > LG WM2688H Front Load Washer
LG WM2688H Front Load Washer, smoking power related issues. ... is it worth trying to fix drum loud and rattles when on spin cycle, then smoke started pouring out of ...hi working till smoke came out the back and now no power - Unplug it. ... washer makenoise doing spin cycle smell smoke make the power cord warm to ...
www.appliancepartspros.com > ... > Washer > Kenmore Washer Parts
Rating: 5 - 189 reviews - $32.19
Burnt rubber smell at end of cycle from 11 yr old lg wm2277hw front load washer i hand spun inner drum it was ... Appliance: LG Washer WM2277HW ... Our LG "Tromm"washer (a.k.a. "Trommy Baby") started making a horrible ... The bearings were worn and made very loud noise in the spin cycle John A. • Punta Gorda, FL.
Sep 15, 2010 - Uploaded by djmcarter
I also have an LG refrigerator, which makes a loud sound (it's the.... I am watching your video while mopping up water underneath the exact same machine right now. ... How to Fix an LG Front load washer machine that wont spin - Duration: 5:32. ...
Make sure hall sensor is snapped in to correct location and is secure. Take a look at repair videos from repairclinic.com or appliancepartspros.com for guidance. And the error code is "LE" for sure not "tE" which is sometimes confused between the two.
check under for a broken drive belt
I suspect that it broke and damaged the tub hose to the pump or from the pump to the drain
washer pumps are independent items so it will be something other than the pump
Well Error code EE means (EEprom error) Cause: EEprom is out order. Displayed only when the start / pause button is first pressed in the OC test mode. means there is some problem in the Main Board pcb and it would cost about $150. You need to remove the three screws in back, at top. Slide cover back, PCb is mounted to back wall. Please post comments for further help or information........