Hello Scarletjo1,
What we need to get our arms around your trouble
is for you to OBSERVE of the water collection bucket
is FULL when you start getting water...
~~
Water Pump Drainage:
Remove the rubber cap from the spigot next to the power cord. Attach the rubber tubing supplied to the drainage spigot.
Locate the open end either through the rubber grommet in the window slider kit so it can discharge out through the window,
or
in a suitable discharge drain. ( Fig. 10 )
The pump will engage once the bucket is full.
Continuous Drainage:
Remove the supplied rubber stopper from the hose connector. Screw a suitable
length of hose onto this connector. Place the open end into a suitable drain making sure there are no kinks in the hose.
( Fig. 11 )
~~ (Do check your pump configuration
(This UNIT must be "
set up"... it is not plug & play)
>>
((follow instructions in MANUAL)).
There is a pump... pump controller and "over-flow"
sensor...
all have to be
failing..
cracked or have
leaking O-rings for you to be getting water on the floor
They all source their control from the very same
control circuit PCB (printed circuit board)
See the attached parts list
Frigidaire FAP094P1Z Factory Parts Catalog Page 4
I would suggest you give it a serious look inside
before calling for a "
REPAIR"...
Take pictures BEFORE taking anything apart...
and do check with FRIDIGIDAIR for parts availability at
If there is a question as to where to obtain service, contact our Consumer Relations Department at:
Frigidaire
P.O. Box 212378
Augusta, GA 30917
800-444-4944
My regular parts (bucket)
http://www.appliancepartspros.com/search.aspx?model=fap094p1z
Check your owners manual for "bucket" operation
(Drain)... page 9
and AVOID SERVICE pages (example below)
Frigidaire FAP094P1Z1 Use And Care Manual Avoid Service Checklist
Hope this helps.
Carnac the Magnificent