20 Most Recent
Whirlpool LSR7333 Top Load Washer - Page 3 Questions & Answers
Water wont cut off
Does the water run if you push the timer dial in to stop the cycle or does it run even if you unplug the washer?
12/31/2011 7:43:59 PM •
Whirlpool...
•
Answered
on Dec 31, 2011
How do i pull the
Depending on the agitator style, you'll have either a fabric softener dispenser or just a plastic cap on the top of your agitator. In both cases, you simply pull / pry those components off and you'll see a translucent cap further down with a rubber seal around it. Reach in and pop this cap off. Below it is a single bolt, threaded through the agitator to the agitator shaft. Remove the bolt with a rachet / socket / long extension or a speed wrench.
Now you simply pull the agitator straight up out of the machine. One word of caution... if you have a dual action agitator, there is a plastic gear / dog mechanism snapped inside. If you handle the agitator with care, you'll be fine. If not, this mechanism can come out and easily come apart- not a good scenario. It consists of 6 parts that you'd have to carefully put back together and reinsert.
Happy cleaning and good luck.
1/22/2011 12:40:31 AM •
Whirlpool...
•
Answered
on Jan 22, 2011
Just had machine to a repairman because it
flip up the lid and check the clear plastic hose going to the pressure switch.that's what shuts the water off.if that line is off or has a hole in it the washer will just keep filling and overflow.he must of put a new motor coupling in and the hose could of fell of the pressure switch when he put the washer back together
1/20/2011 12:25:06 AM •
Whirlpool...
•
Answered
on Jan 20, 2011
Washer will not spin. (Washer
Sounds like the drive coupling is bad if you can tilt the machine back with someone holding or prop it against a wall if you see rubber shaving on the floor that are black or white its the drive coupling and it can with it unplugged reach between the motor and transmission where the drive coupling is and see it its got allot of play in it or feels broke or loose very easy to turn them but you will feel play in it hope this helps good luck.
1/7/2011 3:20:44 AM •
Whirlpool...
•
Answered
on Jan 07, 2011
Whirpool Model# LSR7233BQ2 Top
This is a typical symptom of a water inlet valve that has either a clog, or a bad solenoid. You can attempt to clean by shutting off the water source and removing the hoses from the back of the washer. Check the sediment screens in the water valve (this is where the hoses connect) and clean as necessary with cotton swabs. If its not a simple clog issue, you will have to replace the valve. The folllowing link explains how:
http://www.fixya.com/support/r600647-replacing_water_inlet_valve_kenmore
I hope this helps you. If you require additional assistance please let me know.
1/7/2011 12:05:00 AM •
Whirlpool...
•
Answered
on Jan 07, 2011
Not finding what you are looking for?