http://www.fixya.com/support/p437208-uniflame_153100_open_flame_patio_heaterSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comMon, 08 Sep 2008 07:45:23 GMT80http://www.fixya.com/support/t243434-cadet_heater_quite_workingI've got a Cadet C122 wall heater that quite working. There's 240V to the heater and continuity across the reset switch. No continuity across a round metal device that's at the top of the heater above the coils. Is this normal or is this a shutoff...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t281719-pilot_light_will_not_stay_when_egnitionvokera excell 80 boiler. Pilot light will not stay on when egnition switched is released! Pilot light keeps going off and at times will not stay on, hence gas will not egnite to start boiler!Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t287774-presto_quartz_heater_element_1500_wattsI have one of these heaters and it has worked great for years. ?It is kind of a tower and has two heating elements in it but one of them is cracked. Is there anyway to replace the element? I cannot find them anywhere. ?I believe that it is about 17"...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t304099-fake_smssites from where we can send fake smsMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t320379-floor_furnacei got it lit, but i can't get it to kick on....it is a ward heater company 40sdr....also, what is the stick adjustment thingy next to the one marked pilot......i can read the one marked "pilot" but the other one is illegible....it has markings for on...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t324924-wont_stay_lit_after_20_min_bloweri have a procom 3panel natural gas heater serial #3351383-- model mn 180hpa w/manual blower pf06-yjlf. when in operation and the blower on it will run great for 20 to 25 mins and then shut down includeing the pilot light-- if i burn it without the...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t329494-problem_iflo_digistat_rf2_wirelessI am unable to operate my Thermostat properly. I have put it on the Timer setting and set it to come on at 18C at 5:20am and then go off at 23C at 10:00am. It is then set to come back on at 18C at 16:00 anf go off at 23C at 22:00. With the set it...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t335529-storage_heaterOur Creda Night Storage Heater has just stopped working. We have changed the fuse in the socket but it still does not work. Could it be the element. Is there any way of finding out whether the element has gone before purchasing a new one.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t337334-30_000_btu_kerosene_ready_heaterI have a ready heater that is pretty much automatic. Plug and play if you will. it started to go bad a week or so ago and i thought i could solve the problem myself. Thinking logically, first i tested the polarity of the igniter and no problems...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t342274-dont_want_cold_cuz_iam_already_therive got a central air and heater on roof if u turn to on fan kicks on and off whith control but no hot air will come out just that cold air that i dont want to feel cuz iam alredy cold thats y i wanted the heat system tio work pleas gve idea also...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t347594-sterling_mobility_scooter_diplomat_408trying to get user and electrical wireing diagramMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t348209-dayton_3e219eunit turns on and fan blows for apx 5 sec but will not light. I did just put a new inginter on it any ideas?Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t348834-procom_ventfree_natural_gas_30_000btuI wood like to change heater to Propane .I am looking for a kitMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t359509-voltage_light_comes_shuts_off_heaterWhen I turn it on it fires up o.k. but after about 10 seconds the voltage light blinks on and kills it. I checked the ground wires and they seem fine.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t360204-troubleshooting_techniques_natural_gaswhere can I get info regarding troubleshooting techniques for natural gas spark ignition modules.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t360939-all_pro_60_000_btu_multi_fuelwont start, powers on, spits a cloud of smoke and shuts off. I'm burning #2 diesel fuel, worked fine until last 2 times, particularly bad in sub-zero weather.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t366934-heater_not_working_rightmy desa ventless heater is putting out a very bad odor and is putting a very bad smokey film on anything around it. The heater is about 2 yrs. old.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t371899-electric_baseboard_thermostat_wiringI am replacing the thermostat for my 2 electric baseboard heaters and the replacement unit I bought has 4 wires, red, white, green and black while the old uint had just red and black. There are 3 white wires, 3 black wires and bare solid copper. I...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t376804-space_heaterOne of the 2 quartz elements had burnt out. Is there a replacement available.??Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t379839-lowes_item_number_140389My 40 gal hot water heater wil not work the water wont get hot we just installed itMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t398534-reedy_heater_110_proheater runs a few min,s then it shut,s off . what is the answerMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t403094-identifying_electronic_componentI have a component that looks like a resistor but only haves two colour bands could you suggest what it may be it is on the circuit board of an incubatorMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t388604-mattress_pad_1_2_not_heating_k85kqpOnly 1/2 of the pad is working. I did check all connections and all are good. I have an Induction tester for ac power this showed power on 1/2 of the pad and NO POWER on the other half. In fact this tester will find an open circuit but no such thing,...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t434334-holmes_tower_quartzthe wire from the off- low - high switch to the top of the element burned into. there are 2 small diode looking parts spliced into the wire this is where the problem happened. what are these? do i need them? if so where can i get them? thanksMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t445304-heater_wont_igniteHeater goes through it cycle but ignitor wont glow. Replaced ignitor/pilot assembly.no effect. pulled plug on ignitor and tested for power to ignitor on gas valve pins. I can get 25 volts on one pin if I test to ground. If I test to the two pins I...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t495974-rinnai_2001_gas_heater_turn_offHi, My gas heater turns off after about ten minutes. I am assuming it is a safety feature when the thermostat gets to hot. The cuase I don't know. I paid a repairer $99.00 12 months ago to vacuum the heater, but it still keeps happening. Any ideas?...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t603304-portable_radiant_convector_heater_burnerhi there i have an everdure bridadier 25mj portable gas heater. 2 of my 7 burners are not working properly. they do seem to have a flame behind them but they are not burning as brightly as the other burners. how can i fix this problem? does anyone...Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t613114-1000_000_btu_reddy_heaterNeed a wiring diagram for old heater 1984 I thinkMon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t849899-cannot_start_brivis_heating_deviceThe screen on the wall has several buttons incl "fan" at the top and three at bottom..Auto, Mode and Prog. "Fan" starts the actual fan but with no heat emerging. Pressing the others makes no difference except "Prog" shows days ?and time etc.Mon, 08 Sep 2008 07:45:23 GMThttp://www.fixya.com/support/t13824-just_installed_gas_heater_am_concernedI just installed a gas heater and I am concerned that it might not be big enough to heat my pool effectively. It seems to take about 5 hours to bring the temperature up about 3 degrees. is it normal?Mon, 08 Sep 2008 07:45:23 GMT