20 Most Recent Avanti W789SA Top Load Washer Questions & Answers


firstly,the machine will not spin if water is in it.the spin cycle starts when the tub is drained of all water.you seems to have one or a combination of these problems; drainage/blockage/pump motor/no signal/no voltage.does the machine complete the wash cycle?

Avanti W789SA... | Answered on Jun 07, 2016


Yes,it is located at the top rear portion of the machine and two white wires are connected to it.To gain access,remove two screws holding the cover(from the rear).

d45b7517-bea5-4094-9d13-30dd96b3ff6e.jpg


lid-swith-located-in-avanty-washer-1ui2s4qyphlo3p1h41uwgb2a-2-2.jpg


lid-swith-located-in-avanty-washer-1ui2s4qyphlo3p1h41uwgb2a-2-2_0.jpg


lid-swith-located-in-avanty-washer-1ui2s4qyphlo3p1h41uwgb2a-2-4.jpg

Avanti W789SA... | Answered on May 22, 2016


Dear Customer,
I recommend you to follow the below stated routines
  • Test the lid switch
  • Test the timer control
  • Test the centrifugal switch
  • Test the water level switch
  • Inspect the motor coupler
  • Inspect the drive belt (belt drive only)
  • Inspect under the washer for soot (clutch)
  • Test the motor
  • Inspect the pulley
  • Test the transmission

  • And as for the clothes being wet after the spin..This may be a spin problem or a drain problem

    Drain:
    • Make sure the drain line is clear
    • Check the drain hose for a partial blockage
    • Inspect the water pump
    Spin:
    • Test the lid switch
    • Test the timer control
    • Test the centrifugal switch
    • Test the water level switch
    • Inspect the motor coupler
    • Inspect the drive belt (belt drive only)
    • Inspect under the washer for soot (clutch)
    • Test the motor
    • Inspect the pulley
    • Test the transmission
    Please rate this Solution.. Thank You.. Good Luck..

    Avanti W789SA... | Answered on May 22, 2016


    You just have to replace it. Try these sites for spares with your model number, etc:
    RepairClinic.com
    espares.co.uk
    AppliancePartsPros.com

    mcminone.com

    Avanti W789SA... | Answered on Mar 24, 2014


    Hi


    Thanks for using FixYa. Usually water not draining at all is due to the drain line that is clogged and/or because of kinked drain hoses that’s attached to the Drain Pump. In many washers, a small sock or other piece of clothing can get between the clothes tub and the outer tub that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that's attached to the pump--or even into the pump itself. If it's in the pump, you need to remove the hoses from the pump and pull the item out. To remove the sock from the outer tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers try to grab and remove the clothing through the port. Sometimes you can't remove the stuck clothing from below. Then you have to remove the agitator, top of the outer drum shield, and inner clothes tub. If you think that this isn't easy to do--and you may need special tools—then you might be happier getting a qualified appliance repair technician to do the job. If the drain line isn't plugged, the problem may be with your pump. Even if the pump appears to be turning, the internal impeller may be broken. If so, you need to replace the pump. Please do accept the solution if the issue is resolved or post a comment for further assistance.


    Thanks
    Rylee

    Avanti W789SA... | Answered on Oct 19, 2013


    It may be a bad belt. Check the spin bearing and the basket drive also. Both of these control the spinning of the machine. If you have a question, let me know. I am here to help you the best I can.

    Avanti W789SA... | Answered on Jun 30, 2013


    It may not be draining very well.

    I have a front load washer and run a cycle of a few cups of bleach through mine every couple months.

    I also add vinegar to most washes but that's due to my teenage son's athletic wear.

    Both those things do the trick.

    You shoudl probably check the mechanics as well but the above is a stop gap.

    Avanti W789SA... | Answered on Sep 15, 2012


    clogged drain check your drain pump

    Avanti W789SA... | Answered on May 13, 2011

    Not finding what you are looking for?
    Avanti W789SA Top Load Washer Logo

    41 questions posted

    Ask a Question

    Usually answered in minutes!

    Top Avanti Washing Machines Experts

    Jim Thurston

    Level 3 Expert

    672 Answers

    No_ky

    Level 2 Expert

    59 Answers

    Kolbrun...

    Level 3 Expert

    1215 Answers

    Are you an Avanti Washing Machine Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    View Most Popular

    Avanti Washing Machines

    • Avanti Washing Machines

    Most Popular Question

    machine not drain spin

    • Washing Machines
    Loading...