http://www.fixya.com/support/p42738-candy_aqua1000t_front_loadSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 17 Dec 2009 23:22:39 GMT80http://www.fixya.com/support/t211549-washer_stops_dead_immediately_priorMy Aqua1000T stops dead immediately prior to the final fill of the final rinse. Otherwise it works ok on all programs. I have swapped out the mainboard for another one, yet the problem persists. Any ideas ? I doubt it's the heating element as...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t274783-candy_aquaviva_1000_esduring the was & heating cycle some water is drained and cold water is added on a short time loop. The correct wash temperature is then not reached, but wash continues. This started of intermitantly but is getting more constant now. The mashine...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t280981-intermittent_faultduring the wash & heating cycle some water is drained and cold water is added on a short time loop. The correct wash temperature is then not reached, but wash continues. This started of intermittently but is getting more often now. The machine...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t2812634-candy_aq_1200_fills_water_drum_turns_sI have a candy AQ 1200, it fills with water then stops.. if i turn it off and put it on fast spin the water drains then the drum turns slowly a few times then stopps.. if i turn it off then back on it does the same.Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t2841374-instruction_mannualINSTRUCTION MANNUALThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t3238934-candy_go_147_pump_stopped_workingmy candy GO-147 pump has stopped working. it has a constant supply, but will not run on any cycle ?Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t115189-noise_end_spin_cycleWhen machine is at end of spin, the drum vibrates and makes thumping noises as though clothing is not evenly distributed. Does this even when machine does not have cloths inside. Also noticed small spot of oil on floor under machine. What...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t101619-walking_machineMy washing machine shakes, vibrates and "walks" accross the room! What's wrong with it??Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t360294-candy_washing_machine_c514_manualCandy washing machine C514 manualThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t1895949-washing_machine_bekocant find serial numberThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t299369-washer_stops_in_rinse_cycleHello, We have a problem with our Kenmore Mod. 110-88762793. Every time we do a load of wash it stops in the rinse cycle, it does not spin and the water does not leave. The machine remains full of water. THis happens in all cycles. What can it be?...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t349734-washer_troubleHello I have a HE front loader that is flashing the codes dL F and does not work. Any suggestions? ThanksThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t351859-slow_spinning_washerI have a Maytag washer that has started to spin to slowly. The laundry still drips when you take it out to put it in the dryer. Suggestions? Practical to fix?Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t437259-washing_machineMy washing machine is a Whirlpool Model LA5800XS. It came with our condo unit. Its probably about 20 years old and gets only about three month's use each year. Mechanically it runs fine but the cold water does not run fully. It takes forever to...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t465649-7_5_kg_f_amp_p_washing_machine7.5 Kg F&P washing machine, purchased in 2000. On turning machine on, the usual sequence of lights come on then when the lights are off, I turned it on (normal wash), did not change any settings. Water turned on and off a few times then error...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t505424-replaced_waterI have replaced the water distribution part on my aeg 72620 Lavamat as the original part was faulty. With the new part fitted and on a main wash the water is diverted to the pre wash compartment - is the timer / control pcb faulty also?Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t508194-kichen_aid_modelHave a kichen aid model kaws777e need to remove agitator -need to lookunder for lost necklace.Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t527739-washing_machine_goes_upMy washing machine goes up to the rinse cycle, the tub is filled with water, but it does not move forward to drain and spin. It sounds like the dial on top of the machine stops moving forward. It won't go past rinseThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t498334-when_press_buttonWhen you press the button to select the right cycle the time comes up, you press start you can hear the door click to lock but then nothing happens!! either the code F12 comes or it says 'door' even though the door is fully shutThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t102524-washing_machine_creda_front_loadercannot open the door to emptyThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t194734-instructions_washing_machine_bosh_wfti have a problem. i don't know how to use it in the right way. i don't have the instructions and even if i would have them, they are in german and i wouldn't understand it! can u help me?Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t446149-slow_or_no_drain_from_kenmore_he3tFor awhile now, our washer has been having drain problems that have been getting gradually worse. We get the F02 error; sometimes we can just run it again. Sometimes, it seems to depend on how big the load is. Now, sometimes, it doesn't seem like the...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t1156979-beko_wma_642_w_washingbeko wma 642 w washing machine not spinningThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t103819-washerhi my washer was making a lot of noise last night now it wont spin at all is my belt broke or just loose?Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t428159-samsung_j1045_front_loading_washingThe machine makes a loud banging noise when the drum is rotating. It sounds like its hitting something on each rotation. I have found pieces of what looks like industrial staples in the drainage outlet. I have not lost anything from my washing that...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t158394-maytag_washer_pav2300_water_over_flowFairly new washer, no problems until now. Regardless of load size selected tub fills to top, then over fills. Water continues to flow during agitate cycle. Water continues to flow after rinse cycle, Water continues to flow during spin cycle. Water...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t116259-malber_p21_spinI just bought a slightly used p21 washer. When it finishes its cycle, no matter the type, it WILL NOT spin. Suggestions? Ideas? Recommendations? GMThu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t116324-washer_doesnt_work_properlyHi, I have a problem about my washer, I hope someone may help me out. When I start the washer, it fills the water and washes for about 2 minutes then it starts to fill water again without stopping! Even I after I turn off the power and turn it on...Thu, 17 Dec 2009 23:22:39 GMThttp://www.fixya.com/support/t303664-whirlpool_duet_washer_trouble_code_f25Whirlpool Duet Washer Model WFW9200SQ22 Trouble Code F with flashing 25 Per manual, PAUSE/CANCEL twice, DRAIN/SPIN and START. Washer pumps out water, then attempts to spin. Does not happen. Washer stops with F25 error code. Whats happening?Thu, 17 Dec 2009 23:22:39 GMT