20 Most Recent
Kicker 06ZX750.1 Car Audio Amplifier Questions & Answers
Kicker 750.1 Amp wont play music
it is probably the rca inputs on the amp may have fried. was your cd decked turned up loudly before the power went out? did any wires accidently touch each other? If had worked fine and then suddenly stopped, than either a wire came loose or the inputs fried. try using different cables and I also suggest disconnecting power for 24 hours and then reconnect. If the green light is on then it is getting power and the problem is in the rca cables or the inputs
Power
USE PROPER GAGE WIRE CHECK ALL FUSES TO THE BATTERY,THE FUSE ON THE AMP,MAKE SURE YOUR CONNECTED TO ELECTRICALANNTENA POWER WIRE ON STEREO (ITS USUALLY BLUE WIRE OR OARNGE WIRE ON BACK OF STEREO)BE SURE YOU HAVE A GOOD CLEAN METAL TO METAL GROUND WIRE CONNECTED TO BODY CHASSIS///SOME NEW STEREOS HAVE DIFFERENT WIRES ON THEM FOR CONNECTING AN AMPLIFER BE SURE TO CONNECT TO THAT WIRE THE REMOTE AMP PWR WIRE
Goes into protection mode for no reason
if the amp is powering on the sub and playing and then turns in to protect mode it could be the amp is getting hot and its kicking into protect so you wont fry the amp
The amp has constant power,
This amp likely has several capacitors inside that drain very slowly after being unhooked. If you keep monitoring the voltage, you should see it go down slowly over several minutes.
I just got a s12l7
ABSOLUTELY!!!!! 4 ohms is the load that all amps are designed to play at. A lot of amps will play at lower loads but that equates to more heat. Less heat means longer amp life!!!
Protection light on Kicker ZX700.5
Considering you just bought it, the amplifier itself is probably not the issue. Small chance it is, but we'll go with that a last resort. Have you hooked it up without any speakers connected? Does the light still come on? Describe all the connections you have made to amp (what came from where, and what terminals it is connected to.)
Hola por favor necesito el
debes revisar todos los transistores que no esten da?ados.se miden con un multimetro y se supone que midan de 500-700 ohmios
Not finding what you are looking for?