20 Most Recent
Kaz Honeywell Tower Air Purifier with IFD (HFD-120) Air Purifier Questions & Answers
Reset filter
The solution is simple. Just press on the little red light that says to reset filter. Its a button that will reset the warning and the light should go out
Kaz Honeywell Tower Air filter rest light
When the filter monitor light remains on, it is time to check/clean the IFD™ filters and reset the filter
monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED
filter check light and hold for approximately 5 seconds until the light turns off (Fig. 3). Depending upon
your individual usage (environment and hours used), you may need to check and clean the filters more or
less frequently. If the IFD™ filters are cleaned before the filter monitor light turns on, the filter monitor
should be reset at the same time.
I have a Kaz Honeywell
Hello,
Check
to see if there is power getting to your device. If it is a
110-volt unit, plug a lamp or other device into the same outlet the device is plugged into. If there's no power, check the fuses or
circuit breakers. If there's still no power, you will need to contact a
qualified electrician to restore power to the outlet.
If there is power to the appliance but it is still completely dead there may be a problem in one or more of the following areas:
Wiring (Inspect for any broken or burnt wiring)
Selector switch
Control board
Work on these areas of an appliance may require help from an appliance repair person or other qualified technician.
Take care.
10/10/2010 9:26:29 PM •
Kaz Air...
•
Answered
on Oct 10, 2010
Not finding what you are looking for?