ivNotice for customers in the U.S.A.Federal Communications Commission (FCC) Radio Frequency Interference StatementD70Tested To ComplyWith FCC StandardsFOR HOME OR OFFICE USENoticesCAUTIONSModifi cationsThe FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Nikon Corporation may void the user’s authority to operate the equipment.Interface CablesUse the interface cables sold or provided by Nikon for your equipment. Using other interface cables may exceed the limits of Class B Part 15 of the FCC rules.Notice for customers in the State of CaliforniaWARNING:Handling the cord on this product will expose you to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.Nikon Inc.,1300 Walt Whitman Road, Melville, New York11747-3064, U.S.A. Tel.: 631-547-4200• No part of the manuals included with this product may be reproduced, trans-mitted, transcribed, stored in a retrieval system, or translated into any language in any form, by any means, without Nikon’s prior written permission.• Nikon reserves the right to change the specifi cations of the hardware and soft-ware described in these manuals at any time and without prior notice.• Nikon will not be held liable for any damages resulting from the use of this product.• While every effort has been made to ensure that the information in these manuals is accurate and complete, we would appreciate it were you to bring any errors or omissions to the attention of the Nikon representative in your area (address provided separately).This equipment has been tested and found to comply with the limits for a Class B digi-tal device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful in-terference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-aged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving an-tenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/television technician for help.
Guru