20 Most Recent
Hotpoint WMTL80 Top Load Washer - Page 5 Questions & Answers
WASHING MACHINE DOOR IS STUCK ON HOTPOINT EQUALTIS MODEL HAS FLASHING LIGHTS AND F06 ON DISPLAY
Hi
F06 is for a door lock fault.
In order to get the door open you will need to drain any water still in the tub by lowering the drain hose into a bowl at floor level. This should then allow the door lock to open.
if the door still does not open, then you will need to access the door lock from inside the machine via removal of the top panel of the machine. Check the cable connections to the lock if ok then next check the motor brushes for wear.
How do i remove child lock on Hotpoint WMFG611P washing machine
If the machine has taken in water, and not drained it out. it will prevent the door from opening.
Have you tried draining the machine, and then trying to open the door?? The easiest way it to either set the machine on a slow spin cycle, and allow it to finish that, or if your particular machine has a "drain cycle" ( this feature is not on all models) set the machine to drain, and when it has finished, try opening the door. I hope this helps?
Should you replace a 2010 miccrowave hotpoint that smells hot
It depends on the reason for the hot smell - discovering this would mean a trip to the service shop and weighing the cost of that against a replacement microwave.
Unless your Hotpoint is something special, it is likely a replacement would make sense.
It is wise to periodically measure the power output of a microwave oven by timing the boiling of a measured quantity of water when it is young. When or if the time has extended more than about 10% it is time to think about service or replacement. It is also important to keep the inside of the cabinet clean and all the air vents clear.
Hotpoint aquarius fault code f 05
- F05 - Pressure switch jammed on full
- Thing to do check pump is not blocked and clear it then reset machine by unplugging for 5 mins and plug back in if still gets error F 05 then you need a repair call out. hope this helps.
How to remove hotpoint washer agitator
Using your belt, slip it under the agitator. Give a very hard yank and the agitator will pop up and off. DO NOT HAVE YOUR FACE OVER THE AGITATOR WHEN YOU PULL ON IT. It can pop up with force, and end up breaking your nose! So be careful!
Not finding what you are looking for?