20 Most Recent Hotpoint Aquarius WD640 Front Load Washer/Dryer - Page 9 Questions & Answers


call the parts house appliancepartsdepot and give them the model #
and they will give you the dimensions on the bearing size or which part # to order www.appliancepartsdepot.com

Hotpoint... | Answered on Aug 20, 2012


Hi from retired Englishman in SW France,

Here are my complete guidance notes for checking both the drain motor filter and the drain motor ;-0)

If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!) and most are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play!

REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT!
It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning!

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

Hotpoint... | Answered on Jun 29, 2012


check the wire

Hotpoint... | Answered on Jun 22, 2012


More than likely the door mechanism is faulty and needs to be replaced

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Hotpoint... | Answered on Jun 18, 2012


Hi there, the machine will still work. However it will bounce around all over the place. The concrete block is to hold it down in one place. It needs to be fixed or replaced.

Hotpoint... | Answered on Jun 14, 2012


F-11 means drain pump cannot be activated

make sure wires to pump connected properly

check the pump itself with a meter, (165omhs aprox)

Check the connection on the main power board J9 i think

if all the above is ok you need a main pcb......hotpoint service engineer is the best way to go.

hope this helps.

Hotpoint... | Answered on May 23, 2012


  • F10 - No cold fill. Check that the taps are on or if the drain hoses are kinked.

Hotpoint... | Answered on May 23, 2012


Probably heating element or thermostat is bad.

Hotpoint... | Answered on May 04, 2012

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

906 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

vince

Level 3 Expert

1234 Answers

gbob59

Level 3 Expert

3042 Answers

James Hehling
James Hehling

Level 1 Expert

11 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hotpoint Washing Machines

  • Hotpoint Washing Machines

Most Popular Question

machine fault code f13

  • Washing Machines
Loading...