20 Most Recent Hotpoint Aquarius WD640 Front Load Washer/Dryer - Page 5 Questions & Answers


had this problem today...changed the motor brushes all ok

Hotpoint... | Answered on Mar 14, 2014


1.check if the bra wire is poking out of one of the drums.Check for drum bearing failure if your washing machine is noisy on the spin cycle. Drum bearing failure is common when the bearing seals start allowing water to enter. You can take the belt off and spin the drum by hand, and if the drum rumbles, replace the bearings.

2.clear the water pump from obstractions like coins or small objects there might be some coins stuck in it that are causing discomfort.

if all the above fails try to run the motor alone without the belt if you still hear the noise its the motor that has a problem

Hotpoint... | Answered on Mar 06, 2014


hi pull knob off just check it hasent split on the shaft of knob

Hotpoint... | Answered on Feb 17, 2014


Hi there,

Sounds tricky you may want to try this page, its really helpful.

Good luck.
http://www.buyspares.co.uk/diagnosing-a-faulty-washing-machine/advice-centre.pl?article=409

Hotpoint... | Answered on Jan 31, 2014


Same happened me - the drier heater circuit has a safety cut-out (160°C, Red Spot) which does not reset, the component must be replaced. It is not a simple DIY task as it is fitted from the INSIDE of the air heater duct.

In my case, there were signs of burnt fluff in the duct. I suspect that fluff was sucked into the duct by the fan, dried out, burned and tripped the safety cut-out.

Hotpoint... | Answered on Jan 14, 2014


check the length of the motor brushes.
new are about 30mm long.
should also clean up the motor with compressed air.
Remove the electronic module also do a cleanup in all contacts of connectors. If necessary wash with isopropyl alcohol which can be purchased at a pharmacy.
Dry with a hair dryer.
Do not forget to make reset to clear the error.

(Pressing the start button until all the LEDs light up)

Hotpoint... | Answered on Dec 22, 2013


-There is not fuse. But there are thermal fuse (Possibly 3)
-Disconnect main power and open back panel cover. You'll see it.
-Possibly heater element burn out.

Good Luck

Mai

Hotpoint... | Answered on Dec 21, 2013


Heater Relay fault call Hotpoint

Hotpoint... | Answered on Dec 18, 2013

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

906 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

vince

Level 3 Expert

1234 Answers

gbob59

Level 3 Expert

3042 Answers

James Hehling
James Hehling

Level 1 Expert

11 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hotpoint Washing Machines

  • Hotpoint Washing Machines

Most Popular Question

machine fault code f13

  • Washing Machines
Loading...