Top 20
Soyo Dymond DYLM017A 17" LCD Monitor Questions & Answers
Cannot see the full screen
No, your monitor is needing service
The inverter that corrects the picture and the luminous tube ( florescent) that gives light to the LCD is failing. These and some board components are malfunctioning.
When I try to use my 17
When you power up the compute press F8 key then enter in :"Enable vga mode" then go to display property and set screen resolution to 1024*768.
Then check .
If still same then enter in safe mode and uninstall graphic driver then start computer normal mode then install graphic driver.
Also in safe mode go to start->run type in run "chkdsk /r" then press ok then press "y" then restart computer then it fix and recovers error on harddrive.
Let me know if you need further assistance.
Thanks for using FixYa.
Monitor comes on,then goes off after a couple of
Hi,
This could indicate some component overheating/damaged. I haven't worked on a monitor like yours, but on several occassions I noticed that the problem was caused by blown capacitors. This can usually be spotted if you inspect the capacitors on the logic board carefully. If they are bulging or you can see black goo "leaking" from them then they need replacing. Other than that, troubleshooting of other components on the logic board is far too complicated to describe here.
Hope this helps,
Raf
MISSING POWER SUPPLY
Normally, the polarity is molded next to the connecter hole; it may not be real easy to see.
If you have a digital multimeter with a 'diode' position, most devices have a diode internally installed to prevent damage in case of a bad substitution and the meter will show a value of somewhere between 500-800, typical would be in the mid-600s.
If you find that, then the meter is currently causing the internal protective diode to conduct as it would if the WRONG polarity would be applied and most meters will supply a positive voltage to the red lead for diode function.
Commonly, the center is the positive contact but this sure isn't certain.
Soyo monitors
your monitor doesnt have drivers for it.. and doesnt need drivers for that matter. It sounds like you dont have the right drivers installed for your graphics card. here is a link to the drivers you need.
http://www.nvidia.com/object/winxp_169.21_whql.html
hop this helps, good luck.
Soyo sreen is black cannot sinc with my pc
this can be your computer issue not monitor try connect to other monitor and make sure your computer is working fine ,you can check all the lights on the computer are on and getting no beeps sounds usually you will hear a single beep when PC is booting well
Why has my monitor turned orange. model dylm19r6 computer monitor
If you mean the light on your monitor is orange instead of green, it means the monitor is not receiving data from the computer.
Here's some tricks I would try...
1. Verify the monitor's power cord is plugged firmly into the wall outlet and the back of the monitor.
2. Verify the monitor cable is firmly connected to the computer and the monitor.
3. Verify that you have turned the monitor power switch on.
4. If the power light on the monitor is not on, test the wall outlet (plug in a light or something you know works).
5. If the power light on the monitor is not on, try a different power cord.
6. If the power light is on and yellow or orange or flashing, but nothing displays, or the display is incorrect, borrow a monitor from a friend. If that works, your monitor probably needs replaced.
7. Also, you could try your display on a friend's computer. If it doesn't work, your monitor probably needs replaced. If it works properly on your friends computer, the problem may be with your computers video output port, motherboard video chip (or video card, if you have one), or drivers.
Screen dimmed
The monitor is going bad. The capacitors that drive the screen are getting weak. It is too expensive to fix, you'll need a new monitor.
Not finding what you are looking for?
