EN44INDEXWARNING INDICATIONS(high) (exhausted)Displays the battery remaining power level. As thebattery power comes close to nil, the battery indicatorblinks (battery power warning). When the batterypower is exhausted, power turns off automatically.Appears when no tape is loaded.(pg. 9)CHECK TAPE’S ERASE PROTECTION TABAppears when the erase protection tab is set to “SAVE”while the Power Switch y is set to “” or “”.(pg. 9)HEAD CLEANING REQUIRED USE CLEANINGCASSETTEAppears if dirt is detected on the heads duringrecording or playback. Use an optional cleaningcassette.(pg. 38)CONDENSATION, OPERATION PAUSEDPLEASE WAITAppears if condensation occurs. When this indication isdisplayed, wait more than 1 hour until condensationdisappears.TAPE!Appears if a tape is not loaded when the RecordingStart/Stop Button w or SNAPSHOT Button % ispressed while the Power Switch y is set to “” or“”.TAPE ENDAppears when the tape ends during recording orplayback.SET DATE/TIME!• Appears when the date/time is not set.(pg. 10)• Appears when the built-in clock battery runs out andthe previously set date/time is erased. Consult yournearest JVC dealer for replacement.LENS CAPAppears for 5 seconds after power is turned on if thelens cap is attached.A. DUB ERROR!Appears if Audio Dubbing is attempted on a blankportion of a tape.(pg. 29)A. DUB ERROR!<CANNOT DUB ON A LP RECORDED TAPE><CANNOT DUB ON A 16BIT RECORDING><CHECK TAPE’S ERASE PROTECTION TAB>• Appears if Audio Dubbing is attempted on a taperecorded in the LP mode.• Appears if Audio Dubbing is attempted on a taperecorded in 16-bit audio.• Appears if A. DUB (e) j on the remote control ispressed when the erase protection tab is set to“SAVE”.(pg. 29)INSERT ERROR!Appears if Insert Editing is attempted on a blankportion of a tape.(pg. 29)INSERT ERROR!<CANNOT EDIT ON A LP RECORDED TAPE><CHECK TAPE’S ERASE PROTECTION TAB>• Appears if Insert Editing is attempted on a taperecorded in the LP mode.• Appears if INSERT (w) I on the remote control ispressed when the erase protection tab is set to“SAVE”.(pg. 29)E01, E02 or E06 UNIT IN SAFEGUARD MODEREMOVE AND REATTACH BATTERYThe error indications (E01, E02 or E06) show what typeof malfunction has occured. When an error indicationappears, the camcorder turns off automatically.Remove the power supply (battery, etc.) and wait a fewminutes for the indication to clear. When it does, youcan resume using the camcorder. If the indicationremains, consult your nearest JVC dealer.E03 or E04 UNIT IN SAFEGUARD MODE EJECTAND REINSERT TAPEThe error indications (E03 or E04) show what type ofmalfunction has occured. When an error indicationappears, the camcorder turns off automatically. Ejectthe cassette once and re-insert it, then check if theindication clears. When it does, you can resume usingthe camcorder. If the indication remains, consult yournearest JVC dealer.
Wiz