20 Most Recent
GE Wireless Optical Mouse Questions & Answers
GE Mini Mouse 98563
Hi, I had the same problem. The USB device has what appears to be a circle with dots connected to it facing the port. The dots are actually the word "Connect" in infintessimally small letters. Plug it in, then use your thumb to press down on the circle while using another finger to press up on the device's underside - in effect, squeeze it between your fingers where the circle is. You'll see a red light blink. At that point you can push the "connect" button on your mouse and it will work.
Mouse Acting Strange
The surface it's sliding on can be a factor; if it's reflecting off of a glossy surface, that can cause it to skip or pause. If thre's a touchpad, turn it off to improve mouse performance.
Batteries for GE wireless optical mouse
Normal
0
The GE mouse doesn't have a little door to open on
the bottom, Try this.
Just behind the Left and Right keys where your hand rests,
apply firm pressure down on the cover and slide to the rear.
Some mouse manufactures have used this type of access to replace the
batteries.
Hope this helps. Bud
I have a GE 99916 wireless mouse. When it's
To get this working again, I had to go through the Device Manager within the Control Panel > All Control Panel Items. If you right click on Mice and other pointing devices > HID-compliant mouse and then click on Properties, you will get a new window. Within that, you will need to go to the Driver tab, click "Uninstall", verify, and then re-insert the USB dongle at that point. This is what worked for me.
I can not remember how
Hi there, After the light starts blinking on ur usb adapter just press the button bellow ur mouse. Should work.regards,
My new GE 98812 ergonomic wireless mini mouse
on the bottom of the GE wireless mouse there is a connect button make sure to push it one time then on the usb there is a connect circle hold it as if you were going to pinch it sounds dumb but I was just having the same problem and I read one of the solution fixes and it said to push connect button on back of mouse and also push it on the usb where it says connect even though the one that you push on the usb stick isn't a button but it is sensed once held with pointer finger and thumb hope this better describes it to fix it
99914 ge
see if the pc recolonize it when you plug it in it should if not you may need to reload the drivers manually.
Why won't my mouse turn on
see if the pc reconiziez it when you plug it in it should if not you may need to reload the drivers mannualy.
GE Wireless "Malfunction" "Unknown Device"
Does the mouse and/or keyboard have a "connect" button on the bottom of either? Try restarting your PC, then, if you have installed new batteries, and the mouse/keyboard is still not connected, try the "Connect" button if any.
How to setup ge 99916 wireless mouse
Instructions
-
- 1Hold the mouse in your hand, press down on the battery compartment cover (the back of the mouse) then slide it off.
- 2
Insert two AAA batteries into the mouse. Make sure the positive and negative terminals match up with the diagrams inside the battery compartment.
- 3
- Replace the battery compartment cover.
- 4
Connect the USB receiver to a USB port on the computer. The computer will acknowledge that a new device has been installed and you will be prompted to install the software.
- 5
Insert the software installation disc into the optical drive. Follow the instructions provided by the installation wizard to install the software.
- 6
Press the link button on the receiver, then turn the mouse over and press the link button on the mouse. The mouse is ready for use.
Not finding what you are looking for?