Top 20 HP Compaq nx9010 Questions & Answers


You may still be able to from the recovery partition. Press F8 just before it boots and select recover. Otherwise insert your XP OS disc and start from scratch.

HP Compaq nx9010 | 22 views | 0 helpful votes


YOU HAVE TO OPEN THE LAPTOP FROM THE BOTTOM TO REMOVE THE BATTERY OF MAINBOARD . AFTER THAT MAINBOARD RESETS TO ITS DEFAULT VALUES. FIRST OPEN THE ACESS PANELS TO SEE IF YOU HAVE ACESS WITHOUT TO OPEN ALL THE LAPTOP. FOR FURTHER INSTRUCTIONS SEE VIDEO ON YOU TUBE FOR DISSASSEMBLY

HP Compaq nx9010 | 45 views | 0 helpful votes


Take it to a computer expert with proof of ownership.

HP Compaq nx9010 | 26 views | 0 helpful votes


qaqawwwwwwwwwwwwwwwww

HP Compaq nx9010 | 38 views | 0 helpful votes


If you have a external keyboard available this would probably get you out of a jam so long as there are no other issues with the laptop. The computer keyboard will need to be replaced since it is locked down.

HP Compaq nx9010 | 274 views | 0 helpful votes


Ensure the application that opens Socrates files is installed- I'm guessing one of these software solutions:

http://www.intercorr.com/software/socrates/socintrfc.html

Once an application that can open .soc files is installed, you should be able to right click on the .soc file, and choose the application you want to view the file with.

HP Compaq nx9010 | 159 views | 1 helpful votes


Re-install yahoo and try again, if still not running, re-install your operating system

HP Compaq nx9010 | 55 views | 0 helpful votes


Hi,

This could be because the key is stuck inside. Tap the J Key gently or a bit hard or try to pull it out ( dont remove it off ). Normally hitting a bit hard on the Key solves the problem.

Regards,
Ron

HP Compaq nx9010 | 578 views | 1 helpful votes


Disconnect the mother board battery, the old pass, if any, will go away. You may want to check the voltage on the battery. It may not be enough to maintain the settings for you; it may require replacement.

There is really very little purpose for putting a password on the CMOS, BTW.

Thanks for your question.

HP Compaq nx9010 | 78 views | 0 helpful votes


I came across this kind of situaiton on my HP laptop (win 7) and ended up with eliminating it with a boot program called BuitSuite and it helped entered my Windows and resolved the program. It seems that there is a system file missing which lead to error loading error when you boot. Hope it will also help in your case, best regards.

HP Compaq nx9010 | 127 views | 3 helpful votes


There is a great article at Working with Windows Wireless Networks
If you need more help post back! Thumbs and testimonial are welcome!

HP Compaq nx9010 | 46 views | 0 helpful votes


Hi there,
Reinstall the system and it will be OK.Then use a data recovery program to get your files back.
It is easy to recover the files.
Download this program called Tenorshare Data Recovery and run it.There are four steps to do:
1. Select deleted recovery. It will take you a few minutes to scan your note book;
2.You can see all files listed on the task window, click the files you want to recover;
3. Select a path folder for the recovered files to save in;
4. Click "OK" to finish recovery.
You can get the program here:
http://www.any-data-recovery.com/product/index.htm

HP Compaq nx9010 | 155 views | 10 helpful votes


Here is the info for the error 0280

0280 Previous boot incomplete-Default configuration used

Previous POST did not complete successfully POST loads default values and
offers to run BIOS Setup If the failure was caused by incorrect values that are
not corrected, the next boot will likely fail This error is cleared the next time
the system is booted

Here is the direct link to the Maintenance and Service Guide

http://bit.ly/gBwWBa

Good Luck

HP Compaq nx9010 | 231 views | 0 helpful votes


1. The PC has to support booting from a USB flash/pen/key drive. There may be anywhere from 1-3 items to change in the BIOS to make this possible assuming your BIOS supports it. Some bios's may refer to your flash drive as a USB floppy or USB zip. Of course there are exceptions, perhaps some are covered here.
2. The USB flash drive must support booting from it in general.
3. The flash drive must contain the boot/system files.
4. The flash drive must have bootsector area. This is done with special utilities.
5. References to "A:" drive lines in the autoexec.bat and/or config.sys files you copy to the drive after you make it bootable may result in errors.
6. You "may" have to format your floppy disk first in WinXP before you create a bootdisk as XP may "not" like working later on with a disk formatted otherwise.
7. Included below is a bootable ISO of DOS 7.1 which may be used with some of these methods if you do not have a 1.44 drive.

HP Compaq nx9010 | 1,273 views | 1 helpful votes


Here, check the link below and click on the download button:

http://drivers.softpedia.com/get/GRAPHICS-BOARD/OTHERS/HP-Compaq-nx9010-Video-Driver-80.shtml

This is the VGA driver for your Compaq NX9010.

Thank you and good luck!

HP Compaq nx9010 | 262 views | 0 helpful votes


Check to make sure that you do not have a USB drive plugged-in or a disc in the CD-ROM drive.

HP Compaq nx9010 | 86 views | 0 helpful votes


Get Ubuntu !!!

HP Compaq nx9010 | 75 views | 0 helpful votes

Not finding what you are looking for?
HP Compaq nx9010 Logo

88 questions posted

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Alun Cox

Level 3 Expert

2679 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

HP Computers & Internet

  • HP Computers & Internet

Most Popular Question

windows xp problem opening socrates

  • Computers & Internet
Loading...