20 Most Recent HP Photosmart 2610 All-In-One InkJet Printer - Page 4 Questions & Answers

you have to download it again. the cause is there are some corrupted files on your download. when downloading save the installer to the desktop

Check verry carefully ALL CONNECTIONS. Is the power suply ok.?

Hi,

Please follow the link that I pasted below.

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00219805&cc=us&lc=en&dlc=en

If the issue still persists click on

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&docname=c00256370#c00256370_doc

still unable to fix it! try this link

http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&docname=c00211601

Please let me know the result. Hope it was useful

Follow the instructions in Chapter 8, beginning on page 69 of the manual.

with the 2610, on the right side remove gently the coverplate and then slide the under panel down. There are four places it attaches to the printer case one at each corner approximately. you can try to do what I did and use a greenie flathead screwdriver to pry it free, or do the not so obvious but much easier and kinder to the machine version of pushing it down to get the L shaped plastic pieces to release from the upside down L underneath. then there are three size T10 hex or star shaped screwdriver screws to release three of the four sides. I never could get the front silver fitted piece off, but was able to remove the glass. DO NOT CLEAN WITH WINDEX...IT LEAVES RESIDUE. USE VINEGAR. ALSO, USE WHITE GLOVES AS any dust you get on it cleaning it will leave small fibers on both sides. I used a special glass cleaning rag and then gently replaced it. note which side the black strip goes when you remove the glass!

I am prining envelopes and got this message twice so far. I just unplugged the printer for a hard boot. Wish someone knew what generates this message though. Annoying.

HP Photosmart 2610 All-In-One Inkjet Printer user manual can be downloaded here.

I have the same problem. come to find out after about 10 minutes of investigating I found that a little plastic piece that holds a small hook shaped metal piece broke off and the metal piece is not making contact somehow to tell the printer that the black ink cartridge is actually in there

Hello Cliff, welcome to FixYa.Hard Reset the printer by doing the following:

• Remove all the ink cartridges.
• While the printer in ON, unplugged the power cable from the power source.
• Disconnect the USB cable at the back of the printer (if your printer is connected through a USB cable)
• Restart your computer.
• Connect back the USB cable.
• Plug the power cable to its power source.
• Turn ON the printer if it does not turn ON automatically.
• Install the ink cartridges.
• If the printer prompts for an print head alignment, please do so.

If the problem persists, replace the ink cartridge. The cartridge might be defective since you already have tried to clean the contacts.Keep me posted.Jas

Need more information please?
have you tried here http://h10025.www1.hp.com/ewfrf/wc/product?cc=au&dlc=en&lc=en&os=228&product=421139&sw_lang=&