In response to the request window. Select Driver from Disk Provided by HardwareManufacturer(or Have Diskdepending on the OS version) and browse to where the SM56drivers are located. Windows should find the information on the disk and identify the device as aSM56 Modem. It then copies the files from the install disk to the computer.Important: The install program may display a message box that reports Cannot locate file....Ifthis occurs, browse and re-point to where the SM56 driver files are located. Then click OK.Installation will now complete.On Data/Fax/TAM and Data/Fax/Speakerphone modems, another device is found after themodem has been installed. Windows notifies you that it has found a Serial Wave Device for themodem and prompts for a Wave Device driver. Re-point to the SM56 driver location and clickOK.When these two devices are installed, the SM56 Modem Setup program runs.The modem setup program for PCI does not prompt for user input during installation. It defaultsto USA country code and Domestic English as the language for the online Help file. If you wishto change these settings, and/or the COM port selection, you may do so via the SM56 ControlPanel application (Start->Settings->Control Panel, then double-click the SM56 Modem icon)after setup is complete. Also, for SM56 Data/Fax/Speakerphone modems the microphone andspeaker gain selections may be done via the Control Panel application (under the Advanced tab).Also, DOS box support is disabled after the SM56 is installed. After install is complete, youmust enable it via the Advanced tab in the SM56 Control Panel application. Make sure the DOSbox check box is checked. If not, click it to check it, exit the SM56 Control Panel application andrestart the computer. You must restart the computer to complete DOS box enabling.7Installing SM56 Software on Windows NT 4.0Important-- The SM56 software for Windows NT is Data/Fax only, there is nospeakerphone or TAM supported.Windows NT 4.0 does not fully support plug and play (PnP). Therefore, after installing themodem board in the computer and booting, the operating system will not automatically recognizethat new hardware is present. You must manually install the modem as follows:Step 1-- Install a COM port for the modemYou must install a COM port for the SM56 modem as follows:1. Open the Windows NT Control Panel.2. Double click the Ports icon. The Ports window opens.3. Select Add.4. Select a COM port number (in the range 1-4 preferably) that is not already installed, andallocate to it the standard resources as follows:COMPortIOAddressIRQ
Guru