2. Locate a vacant PCI bus connector.3. If using the SM56 Data/Fax/Speakerphone modem, connect the sound subsystem interfacecable(s) to the modem card (via the internal TAPI connector or using the audio jacks -- referto the information above on sound card compatibility.)4. Connect the modem Line input to an analog phone jack using an RJ-11 phone cable.Optionally, connect a telephone handset to the Phone input on the line interface card.5. Replace the personal computer cover and power it back on.6Installing SM56 Software on Windows 95/98Note:Windows 95/98 assigns the modem a COM port number. To support older softwareapplications and DOS games the SM56 installation software attempts to negotiate a COM portnumber in the range of 1-4. If the install picks a higher COM port, you can force the COM portselection via the Control Panel application after install is complete.Installing on Windows 95/98(Note: The Install Wizard may vary slightly with different versions of the OS and differentservice packs)On starting Windows for the first time after installing the SM56 line interface card, the WindowsConfiguration Manager detects the new hardware, assigns resources to it, and then displays awindow requesting the modem software drivers. This indicates that the Configuration Manager islooking for the information (INF) file, which contains information about the modem, includingdevice type (Modem), device driver information (the name of the driver that will control themodem) and the AT command/response sets that it supports.
Guru