http://www.fixya.com/support/p37058-roper_rex5635e_dryerSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comMon, 28 Dec 2009 10:33:24 GMT80http://www.fixya.com/support/t3133064-roper_dryer_takes_minute_start_shuts_offroper dryer takes a minute to start then shuts off 2 minutes laterMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t2435761-takes_usually_3_complete_cycles_dryit takes usually 3 complete cycles to dry an average load of clothes.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t1946105-roper_dryer_mod_rex5634kq1_justI have a Roper Dryer Mod# REX5634KQ1. It just stopped drying all together. I didn't have a dryer vent, so I put a piece of stocking on the end of dryer hose. We cleaned that out and took the stocking off. Could this be the heating element gone out?Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t357496-dryer_heating_but_not_dryingDryer heats but takes several times to dry clothes. Have cleaned vents and replaced the thermostat. Still same problem. I have a Roper Dryer made by Whirpool Model REX5634KQ1 Type D433-ELE-2406028-FM54. Please tell me what you think. I...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t1662089-repair_book_belt_replacement_roperI am needing a repair book to replace my belt for my dryer. I bought the belt, but I am unable to figure out how to replace it.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t1589076-manual_installation_partsmod # REX5634k01 I would like a manual with pictures of where the element and other heating parts should be installed. Thank you. Jan Rogers 11e ponte vedra court ponte vedra beach, florida 32082Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t649217-dryer_heats_up_spins_clothes_dontI have a kitchen aid dryer which which spins and heats up but wasn't drying clothes ,we have cleaned out the lint areas real good what else could it beMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t177955-thermal_fuseHow to I find and check a thermal fuse? My venting is fine and I replaced the element.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t201969-electric_whirpool_dyrer_wont_runMy electric dryer will work sometimes, and then all of a sudden won't start. It makes a loud humming sound like its trying to get going, but the drum won't turn and it won't heat up. Sometimes, when it is running, it will stop in the middle of the...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t205089-whirlpool_awz2303_tumble_dryer_onlyMy tumble dryer only blows cold but the drum rotates. I think this could have happened because the filter was not cleaned for 3-4 loads and; therefore, the dryer may have over-heated. I have looked for some kind of obvious reset switch but can't...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t206394-lg_tumble_dryerWill not tumble, can hear motor trying to work and can sometimes get drum going but it will stopMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t210064-tumble_dryerMy tumble dryer still works and turns the clothes but does'nt heat up! Took the back off and can see the heating element but it all looks connected properly and does'nt seem damaged. Will this be expensive to repair?Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t211684-no_heat_whirlpool_gas_dryerModel: LGR4634JQ0 The gas dryer no longer generates any heat. The motor will turn the drum. The timer is somehow affected, because if the dryer is turned on and left alone, it will tumble indefinitely.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t211699-washing_machine_temperatureswhat temperatures are used by the settings on USA washing machines described as cold,warm and hot. The launderette i use in the UK uses USA machines, but the UK instructions on my clothes give temperatures.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t211814-gas_only_comes_couple_cyclesI took the panel off the front and cleaned about a 1/2 inch of lint off of the inside. yikes! There was actually a layer that looked like it had been smoldering. I can see the igniter working and for the first two or three cycles the gas comes on...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t215254-maytag_dryerI have a maytag dryer model # HYE3657AYW It will not start at all. I checked the circuit breaker. i found no problem their.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t216154-whirlpool_calypso_dryer_electricalAfter the dryer has completed a drying cycle, it will not turn back on (after the door has been opened and closed). If the dryer is unplugged for about 15 minutes, it will work again after it is plugged in. Also, the display sometimes comes on by...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t218929-no_heathi i'm Darrell i need some help with my kenmore 80 series dryer if gas. i have gas comeing to the dryer but no heat. can u help me?Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t221289-drive_beltCOULD YOU PLEASE TELL ME IF THE DRIVE BELT IS BROKE WILL THE DRUM STOP TURNINGMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t220664-loose_drum_support_feltI notice that the dryer was making noise with the turning of the drum. I opened up the top of the dryer and found that the felt strip that the drum rides on has come loose. It appears that plastic studs that were used to hold it in place have...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t226329-dryer_hotpoint_dt20I have changed the snapped belt but have knocked 3 wires out of the front I am looking for the wire diagrame so I can plug them back into the right places.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t226644-dryer_not_cominghad to change the wiring and had the wrong wire i needed a four wire and it was a three and i came on with the three wire but after i changed it back in never came back onMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t223774-whirlpool_top_loader_drierModel (Uk) 3LER5436EQ1 Not turning on. Power is to the timer/programmer. Theres continuity on the door switch, thermal fuse, and the off/on button.There is no power to the on/off button however. The thermostat on the heater has continuity.There...Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t227654-dryerdyer heating elment comes on then clicks goes off then comes onMon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t237459-heating_element_stays_after_door_openedIF there is time left on the timer and the door is opened and the dryer tumbler stops. The heating element stays on and never turns off . Only if the dryer timer is at zero (off position)Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t237804-dryer_runs_only_when_start_buttonOur electric dryer will run only when the Start button is held down. Obviously, we can't hold it down for the entire time it takes to dry the clothes. Anybody know what the problem is?Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t239019-dryer_want_turnneed help with dryer, it want turn on (whirlpool)Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t243194-dryer_drum_issuesI have a Kenmore electric dryer. When I turn it on, it heats up and blows, but the drum won't turn.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t246049-gas_dryer_no_heatKenmore front load gas dryer 76801690 Igniter never got hot. Checked ac voltage, never came on. Suspect some wiring or contact issue. I need a wiring and timing chart for the dryer. Just happened over the weekend 11/4/07.Mon, 28 Dec 2009 10:33:24 GMThttp://www.fixya.com/support/t247664-196_degree_non_resettable_thermal_fuseModel # LER3624EQO (or) 0 (Last character is a letter O or numeral 0.? I can't tell for sure)? This is a front loading electric dryer approx 10 yr old.? Dryer will not run, timer works and can be herd ticking, stops when front door is opened.? Start...Mon, 28 Dec 2009 10:33:24 GMT