http://www.fixya.com/support/p36701-zanussi_zt485_built_in_dishwasherSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 24 Dec 2009 15:45:02 GMT80http://www.fixya.com/support/t860253-zanussi_zt485_built_inwhen i press on/off button nothing happening ??checked fuse in plug its ok ?? any ideas please thanks billThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t137716-zanussi_built_in_aquasave_zt_685The dishwashed did not drain properly. When you turn off the machine & start again it sounds like it is starting but there is no sound of water entering. After a few minutes when you open the door a few buttons are flashing.Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t272391-zanussi_dishwasherwasher will go through the wash without heating water ,hence no drying of dishes. not sure of modelThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t166964-blowing_electricsour dishwasher blew th electrics during a normal cycle - thre is now water in the dishwasher that we cannot drain. Everytime we now switch it on it blows the electrics again. Is there a way to drain out the excess water???Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t335115-ge_roll_around_dishwasherdishwasher is at lesast 6 years old I hook it up... turn it to start and it runs but the dial stays in place ... when I opened it there was no water in it... line is clear...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t244263-problem_dishwasherThe machine starts OK, but then the programme no. 2 light flashes and the machine stops. This indicates that the filters need cleaning according to the trouble shooting guide. I have done this and there is no difference. Also sometimes the programme...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t346781-whirlpool_dishwasherdishwasher does not seem to fill up, goes through cycles, clean light flashing at end of wash, soap has not dissolved ( liquid soap), heating element smells very warm turning whiteThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t207262-lower_arm_spinning_slow_intermittentI have cleaned both spray arms and filters and have run the machine with the door open. The lower spray arm spins slowly and intermittent. If I run it with the arm and filter assembly out, the water jet pulses. I would imagine this should not...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t252956-intake_drain_red_light_comes_in_shutsI have had an ongoing problem with the intake/drain red light coming in and shutting down the cycle.I have checked the intake screen/filter and it is clean,I have also cleaned the discharge filter and dismantled the elbow check valve and used a...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t254852-dishwasherit seems as if i have no powerThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t259697-test_bosch_heating_elementmodel shu4022uc/06 stops at wash stall and rinse stall in cycle (manual advance cleans dishes). how?to access heating element to test continuity?Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t264308-delime_light_detergents_not_flowing_intoThe DeLime light will not disappear even after I have a solution to cure this problem thru the dishwasher. Also it will not draw detergent or rinse agent. We have checked the lines and they are not plugged. We also are using the recommended detergent...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t197474-dishwasher_repairDishwasher is a Stoves/Newhome DW616 Rotating spray arms do not always operate. This is an intermittent problem - will sometimes work normally for a few days then arms will not move at all with no water coming from them. Machine appears to go...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t194282-dishwasher_handleThe handle that opens and closes the dishwasher door still works but is very loose. quitThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t208208-kenmore_dishwasher_model_655_notHello, I have a Kenmore dishwasher (model 655) that is not draining the water (during any part of a wash cycle). I cannot find anything that appears to be blocked (took off the bottom spinning wash blade) and the water inlet switch appears to...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t210356-dishwasher_food_cutterThe food cutter came off. Can I simply screw it back on?Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t224666-prima_lpr600not washing, bleeping and giving fault flashes 4 timesThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t226694-require_switch_dishwasherI require the 7 progam selector switch for Kitchenaid model KDS2o Part # PS 1442462. Please advise where I can obtain it ThanksThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t226910-dishwasher_will_not_spray_water_fromI installed a new Maytag Model MDB-7 dishwasher. This is a portable model but I've installed it permanently. There is water coming into the dishwasher but it is immediately draining out so no water will spray from the arms. What controls the opening...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t280157-zanussi_dishwasher_de6850Does not seem to be washing properly and will not dry dishesThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t283814-ge_24in_dishwasher_gsd5630d00wwUnit won't pump out end of normal cycle . Entered In F1 test mode, appears to step through each cycle ok and does pump down to normal sump only level. I have dual pumps, both working and the solinoid & valve next to main (center) pump works. the...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t284744-diplomat_dishwasher_blows_fusesI have a diplomat dishwasher it was working then in mid cycle it blew the house fuse I replaced the fuse in the plug and switched the house fuse back on when turning on the dishwasher it blew again, I was told there is a heater reset button on the...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t290462-dishwasher_power_overloadMy dishlex global 300, completes the washing cycle, but when the drying cycle starts, it overloads and causes the circuit breaker to trip (power points only)Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t308663-ge_built_in_dishwasherthere are several things wrong with my dishwasher right now 1) the soap dispenser dish will not close 2) the dishes are not coming out as clean as I would like 3) the water did not drain from the baseThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t326912-help_dishwashermy 3 year old dishwasher seems to be stuck on the drain cycle. I had water back up into the dishwasher, i fixed main drain line out of the house, started the regular wash cycle then pushed the two buttons simultaneously to cancel and drain. the clean...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t327308-problems_dishwasherThe soap door on my dishwasher is not opening and leaving all the soap in the container during the wash and dry cycle.Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t321170-no_water_enteringworked fine yesterday. Turned it on this morning and had no power. Checked the breaker and it had tripped. Flipped it back on. Unit had power but wouldn't fill with water. Thinking something electrical must have tripped the breaker of course. Checked...Thu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t333992-bosch_model_shu4006c_dishwasherI am noticing a slight 'electrical burning' smell when my dishwasher is running. My first inclination is that the heater element may be failing. We have stopped using the washer until I can diagnose the problem. Any suggestings on repair? ThanksThu, 24 Dec 2009 15:45:02 GMThttp://www.fixya.com/support/t336332-dishwasher_leakingMy dishwasher leaks all over the floor. It comes from the bottom of the washer. How do I fix it?Thu, 24 Dec 2009 15:45:02 GMT