( 7 / 21 ) 4. SERVICE MODE To conduct the following functions, a host computer (Windows 98 / ME / 2000 / XP), printer driver and service tool (QY9-0066) for the iP1500 are needed. Function Procedure Remarks Print head manual cleaning <For reference> Print head deep cleaning Paper feed roller cleaning Select “Cleaning” from the printer driver’s Maintenance.Select “Deep Cleaning” from the printer driver’s Maintenance. 1. Remove the paper from the ASF. 2. Select “Roller Cleaning“ from the printer driver’s Maintenance. 3. Following the instruction from the Status Monitor, load 3 sheets of plain paper in the ASF, and feed them. Cleaning time: Approx. 40 sec.Cleaning time: Approx. 70 sec.Cleaning time: Approx. 2 min. Test printing 1) Nozzle check pattern printing<For reference> Print head alignment Select “Nozzle Check“ from the printer driver’s Maintenance. 1. Select “Print Head Alignment“ from the printer driver’s Maintenance. 2. Select the optimal value using the printed head position adjustment pattern. Nozzle check pattern printing Significant misalignment can be adjusted. 2) Shipment pattern printing - ROM version - Number of pages fed - Waste ink amount Refer to Shipment inspection pattern*1 below. Refer to Shipment inspection pattern sample*2 below. Host computer and service tool are required. EEPROM reset (Reset of waste ink counter etc.)Refer to EEPROM reset / Destination setting*3 below. Host computer and service tool are required. Destination setting Refer to EEPROM reset / Destination setting*3 below. Host computer and service tool are required. EEPROM information check Refer to Shipment inspection pattern*1 below. Host computer and service tool are required. *1 Shipment inspection pattern printing a. Install the print head (QY6-0054-000), and press the Power button to turn on the printer. (The LED lights in green.) b. Load A4-sized paper. c. Connect the printer to the computer. Using the iP1500 service tool (QY9-0066), select “USB PORT.” (See APPENDIX 2, ip1500 SERVICE TOOL.) d. Select “TEST PATTERN 1.” The printer starts printing the shipment inspection pattern. *2 Shipment inspection pattern sample EEPROM contents can be confirmed from the shipment inspection pattern printout (top of the shipment inspection pattern). See APPENDIX 1, SHIPMENT INSPECTION PATTERN 1, for print sample. *3 EEPROM reset / Destination setting a. Install the print head (QY6-0054-000), and press the Power button to turn on the printer. (The LED lights in green.) b. Connect the printer to the computer. Using the iP1500 service tool (QY9-0066), select “USB PORT”. (See APPENDIX 2, iP1500 SERVICE TOOL.) c. <Destination setting> Destination can be set by clicking each model name in “SET DESTINATION.” Confirm the model name by clicking “GET DEVICE ID” after setting change. (If incorrect, it can be changed before turning the unit OFF/ON.) <EEPROM reset> When ”EEPROM CLEAR” is checked, the EEPROM is reset after the shipment inspection pattern printing.
Guru