( 5 / 21 ) 3. ERROR DISPLAY Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor. 3-1.OperatorCallError(LEDBlinkinginOrange)LED blinking Error Corrective action 2 times Paper out Set paper, and press the Resume/Cancel button to feed the paper. 3 times Paper jam Remove the jammed paper, and press the Resume/Cancel button. 4 times Ink tank not installed Re-install the ink tanks, and close the access cover. 5 times Print head not installed or failure has occurred in the print head. (Non-supported print head (see page 4) is installed or print head EEPROM data is abnormal.) Install the print head, and close the access cover. Or, confirm the print head is “QY6-0054-000” and perform re-installation. If not recovered, with the print head installed, power the printer off and on. 8 times Waste ink absorber full or platen waste ink absorber full warning (approx. 95% of the maximum capacity) Pressing the Resume/Cancel button will exit the error, and enable printing. 3-2.ServiceCallError(LEDBlinkinginOrangeand Green Alternately) LED blinking Error Corrective Action 2 times Carriage error Replace the printer as it has failed. 3 times LF error Replace the printer as it has failed. 7 times Waste ink absorber full or platen waste ink absorber full Replace the printer as it has failed. 8 times Print head temperature rise error Replace the printer as it has failed. 9 times EEPROM error Replace the printer as it has failed. 10 times No print head detected excepting print head replacement (during printing) Replace the printer as it has failed.
Guru